Husqvarna SG13B manual Handle Engine Switch, OP Grip Bar, Engine ON/OFF Switch

Page 27

operation

Handle Engine Switch

Set the toggle switch to ON.

Engine ON/OFF Switch

The switch on the engine is disconnected. Use the Handle Engine Switch.

ON

OFF

8060-026

OP Grip Bar

Hold in the bar for the OP grip bar against the handle.

8060-029

Starter Handle

The OP grip bar must be held against the handle when starting the engine.

Misuse of the starter handle can damage the starter. DO NOT twist the starter cord around your hand.

Pull out the handle slowly until the gears mesh. Then give a sharp pull on the starter handle. DO NOT pull out the starter cord completely and DO NOT let go of the starter handle when extended. Return the handle to the recoil position.

Throttle

Keep the throttle at idle. When the throttle is increased, the cutting wheel will begin rotating.

8011-127

28 - HUSQVARNA

Image 27

Contents Operator Manual Contents Introduction Decals and machine-mounted instructions Xxxx xxx xxxx xx xxxx xDecal Decal Important informationGeneral use SafetySafety Preparations Operating Movement/Transport StorageChildren Fuel System Maintenance Personal Protection Equipment Protection equipmentSET-UP Remove air cleaner and double wire clamp from engine Engine Main Components and Controls ControlsSpeed Control Lever EngineChoke Control StarterStarter Handle Fuel ValveAir Filter Spark PlugMuffler Oil Drain Oil DipstickFuel Tank FuelingCentrifugal Clutch Control Panel On/Off Engine Switch Operator Presence OP Grip BarThrottle Brake Handle Adjustment BarPreparation OperationThrottle Starting The EngineFuel valve Choke controlHandle Engine Switch Engine ON/OFF SwitchOP Grip Bar Procedure Set the handle throttle to Fast to engage clutch Transport Operating On HillsBrake Engine switchNormal Shutdown Emergency ShutdownMaintenance Schedule MaintenanceCyclone Filter HUSQVARNA-35 Sludge Reservoir Idle Adjustment Fitting the wrong spark plug type can damage the engine Ignition SystemDrive Belt Cutting Wheel Right Wheel Brake AdjustmentRemoving/Refitting Wheels Left WheelTwo Minute Rule CleaningLubrication Engine Oil Right wheel Throttle cableChecking Engine Oil Level Troubleshooting Engine will not startEngine is weak or runs unevenly Cutting wheel does not rotate Belt not staying tight after adjustmentBelt comes off Belt engages late or slipsWinter Storage ServiceEngine Technical DataDimensions Model SG13BSchematics Delivery service Service JournalService Journal HUSQVARNA-53 Service Journal Limited Warranty Husqvarna S Obligations Under the Warranty 115 151327 IR 03/03/09