Husqvarna SG13B manual Decal Important information

Page 5

symbols and decals

9

3

4

FFO

NO

12

5

11

10

6

Decal 3

Important information

Read and make sure you understand the Operator’s Manual before use or maintenance.

To obtain a replacement manual, contact your dealer.

Observe all safety instructions; otherwise you may injure yourself or others.

Make sure the machine is in serviceable condition prior to use.

Stop the engine and wait until all machine movement comes to a standstill before service, adjustment or cleaning.

Do not run the engine in poorly ventilated spaces.

Make sure nobody is in the vicinity of the machine before starting and during use.

Avoid slopes that are too steep to use the machine safely.

Clear any debris prior to use.

Decal 4

Wear goggles or safety glasses and ear protection when using the unit.

Decal 5

Warning

Engine exhaust, some of its constituents and certain vehicle components contain or emit chemicals considered by the State of California to cause cancer, birth defects or other reproductive harm. The engine emits carbon monoxide, which is a colorless, poisonous gas. DO NOT use the machine in enclosed spaces.

Decal 6

There is DANGER to your feet from the cutting blades.

Decal 9

Rabbit = Fast engage clutch.

Turtle = Slow disengage clutch.

Decal 10

Handle adjustment.

Decal 11

No step.

Decal 12

O = off, I = on

6 - HUSQVARNA

Image 5
Contents Operator Manual Contents Introduction Decals and machine-mounted instructions Xxxx xxx xxxx xx xxxx xDecal Decal Important informationGeneral use SafetySafety Preparations Operating Children Movement/TransportStorage Fuel System Maintenance Personal Protection Equipment Protection equipmentSET-UP Remove air cleaner and double wire clamp from engine Engine Main Components and Controls ControlsSpeed Control Lever EngineStarter Handle StarterFuel Valve Choke ControlMuffler Air FilterSpark Plug Oil Drain Oil DipstickCentrifugal Clutch Fuel TankFueling Throttle Control Panel On/Off Engine SwitchOperator Presence OP Grip Bar Brake Handle Adjustment BarPreparation OperationFuel valve Starting The EngineChoke control ThrottleOP Grip Bar Handle Engine SwitchEngine ON/OFF Switch Procedure Set the handle throttle to Fast to engage clutch Transport Operating On HillsNormal Shutdown Engine switchEmergency Shutdown BrakeMaintenance Schedule MaintenanceCyclone Filter HUSQVARNA-35 Sludge Reservoir Idle Adjustment Fitting the wrong spark plug type can damage the engine Ignition SystemDrive Belt Cutting Wheel Removing/Refitting Wheels Brake AdjustmentLeft Wheel Right WheelTwo Minute Rule CleaningLubrication Engine Oil Checking Engine Oil Level Right wheelThrottle cable Engine is weak or runs unevenly TroubleshootingEngine will not start Belt comes off Belt not staying tight after adjustmentBelt engages late or slips Cutting wheel does not rotateWinter Storage ServiceDimensions Technical DataModel SG13B EngineSchematics Delivery service Service JournalService Journal HUSQVARNA-53 Service Journal Limited Warranty Husqvarna S Obligations Under the Warranty 115 151327 IR 03/03/09