Husqvarna SG13B manual Engine

Page 16

SET-UP

13.Push throttle control lever on console forward to full extent. Pull throttle control lever on engine back as far as possible. Insert “L” end of throttle cable into the outside hole of the engine throttle control lever.

14.Attach the throttle cable to the engine using the double wire clamp removed previously.

ENGINE

THROTTLE

CONTROL LEVER

THROTTLE

CABLE

FORWARD

15.Test throttle control by pulling back throttle handle on console. Throttle arm on engine should be pushed completely forward. Cable should not slip in clamp when doing this test.

16.Test proper wire length by pulling on the handle adjustment lever and raising and lowering the handle to maximum position without any pull on harness.

17.Reattach air cleaner to engine.

18.Remove unit from pallet.

THROTTLE

CABLE

HUSQVARNA-17

Image 16

Contents Operator Manual Contents Introduction Xxxx xxx xxxx xx xxxx x Decals and machine-mounted instructionsDecal Important information DecalSafety General useSafety Preparations Operating Storage Movement/TransportChildren Fuel System Maintenance Protection equipment Personal Protection EquipmentSET-UP Remove air cleaner and double wire clamp from engine Engine Controls Main Components and ControlsEngine Speed Control LeverStarter Starter HandleFuel Valve Choke ControlSpark Plug Air FilterMuffler Oil Dipstick Oil DrainFueling Fuel TankCentrifugal Clutch Operator Presence OP Grip Bar Control Panel On/Off Engine SwitchThrottle Handle Adjustment Bar BrakeOperation PreparationStarting The Engine Fuel valveChoke control ThrottleEngine ON/OFF Switch Handle Engine SwitchOP Grip Bar Procedure Set the handle throttle to Fast to engage clutch Operating On Hills TransportEngine switch Normal ShutdownEmergency Shutdown BrakeMaintenance Maintenance ScheduleCyclone Filter HUSQVARNA-35 Sludge Reservoir Idle Adjustment Ignition System Fitting the wrong spark plug type can damage the engineDrive Belt Cutting Wheel Brake Adjustment Removing/Refitting WheelsLeft Wheel Right WheelCleaning Two Minute RuleLubrication Engine Oil Throttle cable Right wheelChecking Engine Oil Level Engine will not start TroubleshootingEngine is weak or runs unevenly Belt not staying tight after adjustment Belt comes offBelt engages late or slips Cutting wheel does not rotateService Winter StorageTechnical Data DimensionsModel SG13B EngineSchematics Service Journal Delivery serviceService Journal HUSQVARNA-53 Service Journal Limited Warranty Husqvarna S Obligations Under the Warranty 115 151327 IR 03/03/09