Husqvarna SG13B manual Set the handle throttle to Fast to engage clutch

Page 29

operation

5.Tilt the machine on its wheels, lifting the cutting wheel off the ground.

6.Hold in the OP grip bar and start the engine.

7. Allow the engine to warm up for two minutes at idle before grinding.

8060-200

8. Set the handle throttle to FAST to engage clutch.

8060-027

9. Place the middle of the cutting wheel approximately 1" (2.5 cm) above and ¾" to 1½" (2-4 cm) into the stump.

10.Place the cutting wheel in the upper front edge of the stump. Swing the cutting wheel from side to

side while lowering it about 1" (2.5 cm) after each pass until the front edge of the stump is gone.

IMPORTANT INFORMATION

If the cutting wheel is too low, the machine may start to “climb” over the stump and become unstable.

8011-203a

30 - HUSQVARNA

Image 29

Contents Operator Manual Contents Introduction Decals and machine-mounted instructions Xxxx xxx xxxx xx xxxx xDecal Decal Important informationGeneral use SafetySafety Preparations Operating Children Movement/TransportStorage Fuel System Maintenance Personal Protection Equipment Protection equipmentSET-UP Remove air cleaner and double wire clamp from engine Engine Main Components and Controls ControlsSpeed Control Lever EngineStarter Handle StarterFuel Valve Choke ControlMuffler Air FilterSpark Plug Oil Drain Oil DipstickCentrifugal Clutch Fuel TankFueling Throttle Control Panel On/Off Engine SwitchOperator Presence OP Grip Bar Brake Handle Adjustment BarPreparation OperationFuel valve Starting The EngineChoke control ThrottleOP Grip Bar Handle Engine SwitchEngine ON/OFF Switch Procedure Set the handle throttle to Fast to engage clutch Transport Operating On HillsNormal Shutdown Engine switchEmergency Shutdown BrakeMaintenance Schedule MaintenanceCyclone Filter HUSQVARNA-35 Sludge Reservoir Idle Adjustment Fitting the wrong spark plug type can damage the engine Ignition SystemDrive Belt Cutting Wheel Removing/Refitting Wheels Brake AdjustmentLeft Wheel Right WheelTwo Minute Rule CleaningLubrication Engine Oil Checking Engine Oil Level Right wheelThrottle cable Engine is weak or runs unevenly TroubleshootingEngine will not start Belt comes off Belt not staying tight after adjustmentBelt engages late or slips Cutting wheel does not rotateWinter Storage ServiceDimensions Technical DataModel SG13B EngineSchematics Delivery service Service JournalService Journal HUSQVARNA-53 Service Journal Limited Warranty Husqvarna S Obligations Under the Warranty 115 151327 IR 03/03/09