Husqvarna SG13B manual Operator Presence OP Grip Bar, Throttle, Control Panel On/Off Engine Switch

Page 23

CONTROLS

Operator Presence (OP) Grip Bar

The bar must be held against the handle for the engine to run. If the grip is released, the ignition system short- circuits and the engine stops.

WARNING!

Do not over-ride the safety system by binding the bar to the handle.

Throttle

The lever controls engine speed.

With the lever down, the engine runs at idle and functions as start position.

When the engine speed increases, the centrifugal clutch drive automatically engages the cutting wheel.

Control Panel On/Off Engine Switch

The ON/OFF engine switch can be used to stop the engine. The illustration shows the toggle switch in the OFF position (short circuited electrical system).

A second switch with the same function is activated by the OP grip bar.

To start the engine, the control panel switch must be set to the ON position and the OP grip bar must be held in.

ON

OFF

24 - HUSQVARNA

Image 23

Contents Operator Manual Contents Introduction Decals and machine-mounted instructions Xxxx xxx xxxx xx xxxx xDecal Decal Important informationGeneral use SafetySafety Preparations Operating Children Movement/TransportStorage Fuel System Maintenance Personal Protection Equipment Protection equipmentSET-UP Remove air cleaner and double wire clamp from engine Engine Main Components and Controls ControlsSpeed Control Lever EngineChoke Control StarterStarter Handle Fuel ValveMuffler Air FilterSpark Plug Oil Drain Oil DipstickCentrifugal Clutch Fuel TankFueling Throttle Control Panel On/Off Engine SwitchOperator Presence OP Grip Bar Brake Handle Adjustment BarPreparation OperationThrottle Starting The EngineFuel valve Choke controlOP Grip Bar Handle Engine SwitchEngine ON/OFF Switch Procedure Set the handle throttle to Fast to engage clutch Transport Operating On HillsBrake Engine switchNormal Shutdown Emergency ShutdownMaintenance Schedule MaintenanceCyclone Filter HUSQVARNA-35 Sludge Reservoir Idle Adjustment Fitting the wrong spark plug type can damage the engine Ignition SystemDrive Belt Cutting Wheel Right Wheel Brake AdjustmentRemoving/Refitting Wheels Left WheelTwo Minute Rule CleaningLubrication Engine Oil Checking Engine Oil Level Right wheelThrottle cable Engine is weak or runs unevenly TroubleshootingEngine will not start Cutting wheel does not rotate Belt not staying tight after adjustmentBelt comes off Belt engages late or slipsWinter Storage ServiceEngine Technical DataDimensions Model SG13BSchematics Delivery service Service JournalService Journal HUSQVARNA-53 Service Journal Limited Warranty Husqvarna S Obligations Under the Warranty 115 151327 IR 03/03/09