Husqvarna SG13B manual Cyclone Filter

Page 33

MAINTENANCE

Cyclone Filter

The cyclone filter collects the largest contaminant particles, which collect in the container. When you can see a layer of dirt at the bottom of the container, the cyclone housing (1), air channels and air intake screen

(2) must be cleaned.

1	2
	2
	8011-126

Remove the three screw holding the cyclone housing. Remove the housing with the air intake screen and remove the air channels.

The air channels may remain in the upper portion or follow along with the housing when removed.

IMPORTANT INFORMATION

Exercise care when reassembling to avoid damage.

Make sure when mounting that the air intake screen fits exactly in its guide in the upper portion.

Make sure the air channel ends up in the proper position.

Clean the components, using warm water, mild detergent and a sift brush. Dry carefully.

Refit the components. Place the air channels in the cyclone housing. Insert cyclone housing into position and make sure it fits in the upper portion. DO NOT use force; rather coax it into place before refitting the screws.

8011-213

8011-212

34 - HUSQVARNA

Image 33

Contents Operator Manual Contents Introduction Decals and machine-mounted instructions Xxxx xxx xxxx xx xxxx xDecal Decal Important informationGeneral use SafetySafety Preparations Operating Movement/Transport StorageChildren Fuel System Maintenance Personal Protection Equipment Protection equipmentSET-UP Remove air cleaner and double wire clamp from engine Engine Main Components and Controls ControlsSpeed Control Lever EngineStarter Handle StarterFuel Valve Choke ControlAir Filter Spark PlugMuffler Oil Drain Oil DipstickFuel Tank FuelingCentrifugal Clutch Control Panel On/Off Engine Switch Operator Presence OP Grip BarThrottle Brake Handle Adjustment BarPreparation OperationFuel valve Starting The EngineChoke control ThrottleHandle Engine Switch Engine ON/OFF SwitchOP Grip Bar Procedure Set the handle throttle to Fast to engage clutch Transport Operating On HillsNormal Shutdown Engine switchEmergency Shutdown BrakeMaintenance Schedule MaintenanceCyclone Filter HUSQVARNA-35 Sludge Reservoir Idle Adjustment Fitting the wrong spark plug type can damage the engine Ignition SystemDrive Belt Cutting Wheel Removing/Refitting Wheels Brake AdjustmentLeft Wheel Right WheelTwo Minute Rule CleaningLubrication Engine Oil Right wheel Throttle cableChecking Engine Oil Level Troubleshooting Engine will not startEngine is weak or runs unevenly Belt comes off Belt not staying tight after adjustmentBelt engages late or slips Cutting wheel does not rotateWinter Storage ServiceDimensions Technical DataModel SG13B EngineSchematics Delivery service Service JournalService Journal HUSQVARNA-53 Service Journal Limited Warranty Husqvarna S Obligations Under the Warranty 115 151327 IR 03/03/09