Husqvarna SG13B manual Remove air cleaner and double wire clamp from engine

Page 15

SET-UP

7.Set the brake rod assembly into the brake bracket. The brake rod assembly needs to be adjusted before connecting the yoke to the brake. Turning the yoke clockwise shortens the rod, tightening the grip on the brake disc by the brake pads. Counterclockwise loosens the clamping force.

8.After adjustment, attach the yoke to the brake’s top mounting hole using the clevis pin and cotter pin.

9.Turn the adjustment nut against the spring and washer until the spring set snugly against the brake bracket and has a small amount of tension.

With proper brake adjustment, the wheel will slide, but not turn, when the handle is over center.

To engage brake, pull back on the handle until brake rod assembly goes “over center” and locks the brake ON. Test for proper tension and grip.

ADJUSTMENT NUT	BRAKE BRACKET
	BRAKE BRACKET
CLEVIS PIN
HAIR PIN

10.Remove air cleaner and double wire clamp from engine.

CLAMP

11.Route the wire harness from engine and the throttle cable through guide and handle crossmember.

12.Connect upper and lower wire harness together, yellow to yellow—black to black.

THREAD WIRE HARNESS AND THROTTLE CABLE

GUIDE

16 - HUSQVARNA

Image 15

Contents Operator Manual Contents Introduction Decals and machine-mounted instructions Xxxx xxx xxxx xx xxxx xDecal Decal Important informationGeneral use SafetySafety Preparations Operating Movement/Transport StorageChildren Fuel System Maintenance Personal Protection Equipment Protection equipmentSET-UP Remove air cleaner and double wire clamp from engine Engine Main Components and Controls ControlsSpeed Control Lever EngineChoke Control StarterStarter Handle Fuel ValveAir Filter Spark PlugMuffler Oil Drain Oil DipstickFuel Tank FuelingCentrifugal Clutch Control Panel On/Off Engine Switch Operator Presence OP Grip BarThrottle Brake Handle Adjustment BarPreparation OperationThrottle Starting The EngineFuel valve Choke controlHandle Engine Switch Engine ON/OFF SwitchOP Grip Bar Procedure Set the handle throttle to Fast to engage clutch Transport Operating On HillsBrake Engine switchNormal Shutdown Emergency ShutdownMaintenance Schedule MaintenanceCyclone Filter HUSQVARNA-35 Sludge Reservoir Idle Adjustment Fitting the wrong spark plug type can damage the engine Ignition SystemDrive Belt Cutting Wheel Right Wheel Brake AdjustmentRemoving/Refitting Wheels Left WheelTwo Minute Rule CleaningLubrication Engine Oil Right wheel Throttle cableChecking Engine Oil Level Troubleshooting Engine will not startEngine is weak or runs unevenly Cutting wheel does not rotate Belt not staying tight after adjustmentBelt comes off Belt engages late or slipsWinter Storage ServiceEngine Technical DataDimensions Model SG13BSchematics Delivery service Service JournalService Journal HUSQVARNA-53 Service Journal Limited Warranty Husqvarna S Obligations Under the Warranty 115 151327 IR 03/03/09