Husqvarna SG13B manual Maintenance Schedule

Page 32

MAINTENANCE

Maintenance Schedule

The following is a list of maintenance procedures that MUST be performed on the machine. For those points not described in this manual, visit an authorized service workshop.

WARNING!

No service operations may be performed on the engine or unit unless:

The engine is stopped.

The ignition cable has been removed from the spark plug.

The machine is securely parked where it will not tip or begin rolling.

MAINTENANCE INTERVALS - MONTHS/HRS

Daily

-/10

1/25

3/50

6/100

12/300

MAINTENANCE

 

Check engine oil level

n

 

 

Change engine oil 1)

n

 

 

Check air filter

n

 

 

Clean air filter 2)

n

 

 

Replace air filter cartridge 2)

n

 

 

Clean sludge reservoir for fuel system

n

 

 

Check and clean spark plug

n

 

 

Replace spark plug

n

 

 

Check engine switch function 3)

n

 

 

Check idle speed

n

 

 

Check and adjust play in valves 4)

n

 

 

Clean fuel tank 4)

n

 

 

Check, replace fuel lines as necessary 4, 5)

n

 

 

Check throttle and cable 3)

n

 

 

Check blade and cutter 3)

n

 

 

Check decals and warning signs 3)

n

 

 

Check wear and tension on belts 3)

n

 

 

Check chassis, bolts and set screws

n

 

 

Grease the blade bearings (use high temperature grease

n

such as Mobilith SHC 220 or equal)6)

 

Grease the wheels (standard lithium base)

n

 

 

Check tire air pressure (25 psi max)

n

1)First change after 20 hours. 2)In dusty conditions maintenance is required at shorter intervals. 3)Before each use.

4)Performed by authorized service workshop. 5)Performed every second year. 6)Grease every 4 hours.

HUSQVARNA-33

Image 32
Contents Operator Manual Contents Introduction Xxxx xxx xxxx xx xxxx x Decals and machine-mounted instructionsDecal Important information DecalSafety General useSafety Preparations Operating Children Movement/TransportStorage Fuel System Maintenance Protection equipment Personal Protection EquipmentSET-UP Remove air cleaner and double wire clamp from engine Engine Controls Main Components and ControlsEngine Speed Control LeverStarter Starter HandleFuel Valve Choke ControlMuffler Air FilterSpark Plug Oil Dipstick Oil DrainCentrifugal Clutch Fuel TankFueling Throttle Control Panel On/Off Engine SwitchOperator Presence OP Grip Bar Handle Adjustment Bar BrakeOperation PreparationStarting The Engine Fuel valveChoke control ThrottleOP Grip Bar Handle Engine SwitchEngine ON/OFF Switch Procedure Set the handle throttle to Fast to engage clutch Operating On Hills TransportEngine switch Normal ShutdownEmergency Shutdown BrakeMaintenance Maintenance ScheduleCyclone Filter HUSQVARNA-35 Sludge Reservoir Idle Adjustment Ignition System Fitting the wrong spark plug type can damage the engineDrive Belt Cutting Wheel Brake Adjustment Removing/Refitting WheelsLeft Wheel Right WheelCleaning Two Minute RuleLubrication Engine Oil Checking Engine Oil Level Right wheelThrottle cable Engine is weak or runs unevenly TroubleshootingEngine will not start Belt not staying tight after adjustment Belt comes offBelt engages late or slips Cutting wheel does not rotateService Winter StorageTechnical Data DimensionsModel SG13B EngineSchematics Service Journal Delivery serviceService Journal HUSQVARNA-53 Service Journal Limited Warranty Husqvarna S Obligations Under the Warranty 115 151327 IR 03/03/09