Husqvarna SG13B manual Oil Dipstick, Oil Drain

Page 21

CONTROLS

Oil Dipstick

The dipstick for the crankcase oil reservoir is located on the front of the engine. Refill the engine oil in the hole where the dipstick fits.

When checking the oil level, the dipstick should not be screwed in. The machine should be parked on even ground with the engine stopped. Never run the engine without the dipstick in place. The engine has an electronic oil level guard. It stops and cannot be started if the level becomes too low. Yet you should not rely entirely on the level guard; rather you should check the oil using the dipstick.

For normal use, SAE 10W-30 weight engine oil service SF-SG is recommended; see also Lubrication.

Oil Drain

The drainage screw for the crankcase oil reservoir is located on the back of the engine.

IMPORTANT INFORMATION

Used engine oil is a health hazard and legislation prohibits disposal on the ground or in nature; it should always be disposed of at a workshop or appropriate disposal location. Avoid skin contact; wash with soap and water in case of spills.

8011-020

8011-187

22 - HUSQVARNA

Image 21
Contents Operator Manual Contents Introduction Decals and machine-mounted instructions Xxxx xxx xxxx xx xxxx xDecal Decal Important informationGeneral use SafetySafety Preparations Operating Movement/Transport StorageChildren Fuel System Maintenance Personal Protection Equipment Protection equipmentSET-UP Remove air cleaner and double wire clamp from engine Engine Main Components and Controls ControlsSpeed Control Lever EngineStarter Handle StarterFuel Valve Choke ControlAir Filter Spark PlugMuffler Oil Drain Oil DipstickFuel Tank FuelingCentrifugal Clutch Control Panel On/Off Engine Switch Operator Presence OP Grip BarThrottle Brake Handle Adjustment BarPreparation OperationFuel valve Starting The EngineChoke control ThrottleHandle Engine Switch Engine ON/OFF SwitchOP Grip Bar Procedure Set the handle throttle to Fast to engage clutch Transport Operating On HillsNormal Shutdown Engine switchEmergency Shutdown BrakeMaintenance Schedule MaintenanceCyclone Filter HUSQVARNA-35 Sludge Reservoir Idle Adjustment Fitting the wrong spark plug type can damage the engine Ignition SystemDrive Belt Cutting Wheel Removing/Refitting Wheels Brake AdjustmentLeft Wheel Right WheelTwo Minute Rule CleaningLubrication Engine Oil Right wheel Throttle cableChecking Engine Oil Level Troubleshooting Engine will not startEngine is weak or runs unevenly Belt comes off Belt not staying tight after adjustmentBelt engages late or slips Cutting wheel does not rotateWinter Storage ServiceDimensions Technical DataModel SG13B EngineSchematics Delivery service Service JournalService Journal HUSQVARNA-53 Service Journal Limited Warranty Husqvarna S Obligations Under the Warranty 115 151327 IR 03/03/09