Harbor Freight Tools 95668 operating instructions See Figure G, Optional Table Spacer Installation

Page 10

5.Place the Wood Shaper’s Work Table (52) upside down on two sturdy blocks that are at least 3-1/2” off the floor. Make sure the Spindle (105) DOES NOT touch the floor or the weight of the Wood Shaper may damage the Spindle.

(See Figure G.)

6.Place the Stand assembly on the Wood Shaper and attach it with the Carriage

Bolts (9), 3/8” Flat Washers (10), and Hex Nuts (11). Then have an assistant help you turn the Wood Shaper unit upright. (See Figure G.)

7.Level the Wood Shaper with a carpenter’s level. If necessary, move the Stand slightly until it is level. Then, tighten all Bolts and Nuts on the Stand.

FIGURE G

STAND ASSEMBLY

(28)

 

 

(28)

 

(28)

 

(66)

(66)

WORK TABLE

 

 

 

(52)

Optional Table Spacer Installation:

1.Your shaper comes with a Table Spacer Installation Kit that will enable you to make shallow cuts and utilize the upper blade area of most router bits with shanderd-length shanks. This is an optional feature that is not required for most applications.

2.Unplug the shaper power cord. Remove the four table corner Hex Bolts (66), then remove the three Spindle Housing Hex Bolts (95). Lift the Table (52) off of the stand assembly. (See Figure G above and the assembly diagram on page 29.)

3.Locate the package, (included with your shaper), that contains all the hardware for installing the spacers. There should be five M12 Long Bolts (151), two M12 Short Bolts (152) and seven 1/2” Spacers (150). Position one spacer over each of the four corner bolt holes and one over each of the three spindle housing bolt holes.

REV 07j

SKU 95668

For technical questions, please call 1-800-444-3353

PAGE 10

Page 9 Page 11
Image 10
Page 9 Page 11
Contents For technical questions or replacement parts, please call Industrial SHAPER/ROUTERSave this Manual Product SpecificationsGeneral Safety Rules Work AreaElectrical Safety Tool USE and Care Specific Safety Rules ServicePage Grounding Prong Plug and Outlet Outlets for 2-Prong Plug See 3-Prong Plug and OutletSee Outlets for 2-Prong Plug Unpacking Assembly InstructionsStand Assembly See Figure FOptional Table Spacer Installation See Figure GInstalling The Spindle Installing The FencesInstalling The Safety Guard 57, 59. See Figure HHex Nut. See Figure M Figure JSee Figures K, L, and M Adjustments InstructionsRouter Bit Assembly See Figure OFence Alignment See Figure P57, 59. See Figure Q See Figure R Belt AdjustmentTable Inserts Screws. See Figure SCutter Direction Cutter InstallationSee Figure T Setting Spindle Height See Figure Y, nextRub Collars See Figure AAOperating Instructions Cutter. See Figure CCTo Set Up The Wooden Fences For Straight Shaping Start UpSee Figure DD Figure DDTo Set Up The Aluminum Fences For Partial Edge Removal Freehand ShapingSee Figures HH Figure HHPattern Shaping See Figure JJINSPECTION, MAINTENANCE, and Cleaning Please Read the Following CarefullyTroubleshooting Problem Possible Reason Possible SolutionParts List DescriptionWiring Diagram MotorAssembly Diagram Limited 1 year / 90 Day warranty Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800
Top Page Image Contents