Harbor Freight Tools 95668 Table Inserts, See Figure R, Belt Adjustment, Screws. See Figure S

Page 15

Table Inserts:

1.Table Inserts (53, 53A) are used to reduce wood chips falling into the machine which could cause flying debris. Using the smallest Table Insert also covers any unused portion of the bit below the surface of the Work Table (52).

(See Figure R.)

2.Position, and snap in the Table Insert (53, 53A) you wish to use. (See Figure R.)

3.Make sure the Table Insert (53, 53A) is seated and flush with the Work Table (52) surface. (See Figure R.)

FIGURE R

Belt Adjustment:

TABLE INSERT

(53, 53A)

WORK TABLE

(52)

1.The Wood Shaper uses a Belt (123) on two Pulleys (113, 127) to compensate for different Belt positions as the Spindle (105) height is adjusted. To adjust the V-Belt:

Loosen the two Hex Head Screws (134). Slide the Motor (129) position to increase or decrease V-Belt (123) tension, so that the Belt is snug with about 1/4” deflection when pressed lightly with your finger. Then, retighten the Hex Head

Screws. (See Figure S.)

FIGURE S

V-BELT (123)

HEX HEAD SCREW

(134)

MOTOR (129)

SKU 95668

For technical questions, please call 1-800-444-3353

PAGE 15

Image 15

Contents Industrial SHAPER/ROUTER For technical questions or replacement parts, please callWork Area Product SpecificationsGeneral Safety Rules Save this ManualElectrical Safety Tool USE and Care Service Specific Safety RulesPage Grounding See 3-Prong Plug and Outlet Prong Plug and Outlet Outlets for 2-Prong PlugSee Outlets for 2-Prong Plug See Figure F Assembly InstructionsStand Assembly UnpackingSee Figure G Optional Table Spacer Installation57, 59. See Figure H Installing The FencesInstalling The Safety Guard Installing The SpindleFigure J Hex Nut. See Figure MSee Figure O Adjustments InstructionsRouter Bit Assembly See Figures K, L, and MSee Figure P Fence Alignment57, 59. See Figure Q Screws. See Figure S Belt AdjustmentTable Inserts See Figure RCutter Installation Cutter DirectionSee Figure T See Figure Y, next Setting Spindle HeightSee Figure AA Rub CollarsCutter. See Figure CC Operating InstructionsStart Up To Set Up The Wooden Fences For Straight ShapingFigure DD See Figure DDFreehand Shaping To Set Up The Aluminum Fences For Partial Edge RemovalFigure HH See Figures HHSee Figure JJ Pattern ShapingPlease Read the Following Carefully INSPECTION, MAINTENANCE, and CleaningProblem Possible Reason Possible Solution TroubleshootingDescription Parts ListMotor Wiring DiagramAssembly Diagram Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800 Limited 1 year / 90 Day warranty