Harbor Freight Tools 95668 operating instructions Tool USE and Care

Page 4

in. Plugging in power equipment with the Power Switch on, invites accidents.

5.Remove adjusting keys or wrenches before turning the power tool on. A wrench or a key that is left attached to a rotating part of the Wood Shaper may result in personal injury.

6.Do not overreach. Keep proper footing and balance at all times. Proper footing and balance enables better control of the Wood Shaper in unexpected situations.

7.Use safety equipment. Always wear ANSI-approved safety impact eye goggles. Dust mask or respirator, and hearing protection must be used for appropriate conditions.

TOOL USE AND CARE

1.Do not force the Wood Shaper. Use the correct tool for your application. The correct tool will do the job better and safer at the rate for which it is designed.

2.Do not use the Wood Shaper if the Power Switch does not turn it on or off. Any tool that cannot be controlled with the Power Switch is dangerous and must be replaced.

3.Disconnect the Power Cord Plug from the power source before making any adjustments, changing accessories, or storing the Wood Shaper. Such preventive safety measures reduce the risk of starting the tool accidentally.

4.Store idle tools and equipment out of reach of children and other untrained persons. Tools and equipment are dangerous in the hands of untrained users.

5.Maintain this product with care. Keep the Wood Shaper and its Table clean and in proper working order. Properly maintained tools and equipment are easier to control. Do not use damaged tools and equipment. Tag damaged tools and equipment “Do not use” until repaired.

6.Check for misalignment or binding of moving parts, breakage of parts,

and any other condition that may affect the Wood Shaper’s operation. If damaged, have the tool serviced before using. Many accidents are caused

by

poorly maintained tools.

7.Use only accessories that are recommended by the manufacturer for your model. Accessories that may be suitable for one product may become

hazardous when used on another product.

SKU 95668

For technical questions, please call 1-800-444-3353

PAGE 4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents For technical questions or replacement parts, please call Industrial SHAPER/ROUTERProduct Specifications General Safety RulesSave this Manual Work AreaElectrical Safety Tool USE and Care Specific Safety Rules ServicePage Grounding Prong Plug and Outlet Outlets for 2-Prong Plug See 3-Prong Plug and OutletSee Outlets for 2-Prong Plug Assembly Instructions Stand AssemblyUnpacking See Figure FOptional Table Spacer Installation See Figure GInstalling The Fences Installing The Safety GuardInstalling The Spindle 57, 59. See Figure HHex Nut. See Figure M Figure JAdjustments Instructions Router Bit AssemblySee Figures K, L, and M See Figure OFence Alignment See Figure P57, 59. See Figure Q Belt Adjustment Table InsertsSee Figure R Screws. See Figure SCutter Direction Cutter InstallationSee Figure T Setting Spindle Height See Figure Y, nextRub Collars See Figure AAOperating Instructions Cutter. See Figure CCTo Set Up The Wooden Fences For Straight Shaping Start UpSee Figure DD Figure DDTo Set Up The Aluminum Fences For Partial Edge Removal Freehand ShapingSee Figures HH Figure HHPattern Shaping See Figure JJINSPECTION, MAINTENANCE, and Cleaning Please Read the Following CarefullyTroubleshooting Problem Possible Reason Possible SolutionParts List DescriptionWiring Diagram MotorAssembly Diagram Limited 1 year / 90 Day warranty Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800
Top Page Image Contents