Harbor Freight Tools 95668 Unpacking, Assembly Instructions, Stand Assembly, See Figure F

Page 9

UNPACKING

When unpacking, check to make sure all the parts shown on the Parts Lists on pages 27 and 28 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.

ASSEMBLY INSTRUCTIONS

1.CAUTION! Always make sure the Power Switch (5) of the Wood Shaper is in its “OFF” position and the unit is unplugged from its electrical outlet prior to performing any assembly procedures.

Stand Assembly:

2.Lay one Side Panel (1) on the floor and attach the Tie Bars (2) with the Carriage Bolts (9), 3/8” Flat Washers (10), and Hex Nuts (11). Do not fully tighten the Bolts and Nuts at this time. (See Figures D, and E.)

3.Attach the second Side Panel (1) to the assembly. (See Figures D and E.)

FIGURE D

		SIDE PANEL
		(1)
	CARRIAGE BOLTS (9)
	3/8” FLAT WASHERS (10)
	HEX NUTS (11)
		SIDE PANEL
		(1)
	TIE BAR
	(2)
	TIE BAR	RUBBER FEET
	(2)	RUBBER FEET
	(2)	(3)
		(3)

4.Attach the four Rubber Feet (3) to the bottom of the Side Panels (1).

(See Figure F.)

FIGURE E

FIGURE F

SKU 95668

For technical questions, please call 1-800-444-3353

PAGE 9

Image 9

Contents Industrial SHAPER/ROUTER For technical questions or replacement parts, please callGeneral Safety Rules Product SpecificationsSave this Manual Work AreaElectrical Safety Tool USE and Care Service Specific Safety RulesPage Grounding See 3-Prong Plug and Outlet Prong Plug and Outlet Outlets for 2-Prong PlugSee Outlets for 2-Prong Plug Stand Assembly Assembly InstructionsUnpacking See Figure FSee Figure G Optional Table Spacer InstallationInstalling The Safety Guard Installing The FencesInstalling The Spindle 57, 59. See Figure HFigure J Hex Nut. See Figure MRouter Bit Assembly Adjustments InstructionsSee Figures K, L, and M See Figure OSee Figure P Fence Alignment57, 59. See Figure Q Table Inserts Belt AdjustmentSee Figure R Screws. See Figure SCutter Installation Cutter DirectionSee Figure T See Figure Y, next Setting Spindle HeightSee Figure AA Rub CollarsCutter. See Figure CC Operating InstructionsStart Up To Set Up The Wooden Fences For Straight ShapingFigure DD See Figure DDFreehand Shaping To Set Up The Aluminum Fences For Partial Edge RemovalFigure HH See Figures HHSee Figure JJ Pattern ShapingPlease Read the Following Carefully INSPECTION, MAINTENANCE, and CleaningProblem Possible Reason Possible Solution TroubleshootingDescription Parts ListMotor Wiring DiagramAssembly Diagram Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800 Limited 1 year / 90 Day warranty