PRODUCT SPECIFICATIONS
Electrical Requirements | 110 VAC / 60 Hz / 10.54 Amps (With Load) |
| Motor Size: 1 HP / Single Phase |
| Motor RPM: 3450 |
| Spindle Speed: 11,000 |
| Power Cord Length: 70” |
| Power Cord Specifications: SJT 16 AWG x 3C |
| Plug Type: 3 Prong / Grounded |
Spindle Diameter | 1/2” |
Spindle Thread | 12mm x 1.5 pitch, fine thread |
Spindle Travel | 7/8” |
Router Collets | ¼” and ½” (included) |
Maximum Cutting Diameter | |
Table Size | 24” Wide x 19” Deep |
Footprint | |
Miter Guide | 0 ~ 60° Left to Right |
Fence Dimensions | 9/16” Long x |
Overall Dimensions | |
Gross Weight | 187.5 Lb. |
SAVE THIS MANUAL
You will need this manual for the safety warnings and precautions, assembly, operating, inspection, maintenance and cleaning procedures, parts list and assembly diagram. Keep your invoice with this manual. Write the invoice number on the inside of the front cover. Keep this manual and invoice in a safe and dry place for future reference.
GENERAL SAFETY RULES
WARNING!
READ AND UNDERSTAND ALL INSTRUCTIONS
Failure to follow all instructions listed below may result in
electric shock, fire, and/or serious injury.
SAVE THESE INSTRUCTIONS
WORK AREA
1.Keep your work area clean and well lit. Cluttered benches and dark areas invite accidents.
2.Do not operate the Wood Shaper in explosive atmospheres, such as in the presence of flammable liquids, gases, or dust. Power equipment creates sparks which may ignite the dust or fumes.
3.Keep bystanders, children, and visitors away while operating power equipment. Distractions can cause you to lose control. Protect others in the work
REV 10d
SKU 95668 | For technical questions, please call | PAGE 2 |