Harbor Freight Tools 95668 operating instructions Setting Spindle Height, See Figure Y, next

Page 17

2.Place the required spacers, also called Rub Collars (98, 99, 100), onto the Spindle (105). (See Figure V.)

SPINDLE (105)

RUB COLLARS

(98, 99, 100)

CUTTER

(NOT INCLUDED)

FIGURE V

3.Install the Safety Washer (97) and Upper Spindle Nut (96) securely. Tighten the Upper Spindle Nut with an open-end wrench while holding the Spindle (105) at the top with the provided Arbor Wrench (146). (See Figures W and X.)

4.Check to make sure the Cutter (not included) will rotate in the correct direction.

FIGURE W

 

FIGURE X

(146)

 

 

 

 

ARBOR WRENCH

SAFETY WASHER (97)

 

UPPER

 

 

 

 

 

 

 

 

 

 

 

 

 

 

SPINDLE NUT

 

 

 

 

 

 

 

 

 

(96)

 

 

 

UPPER

 

 

 

 

 

SPINDLE NUT

 

 

 

 

 

(96)

 

 

 

 

 

Setting Spindle Height:

1.Correct Spindle (105) height is crucial to most shaping applications. Make sure to use a piece of scrap wood to confirm the correct Spindle height before cutting expensive lumber.

2.Loosen the Spindle Hand Knob (92) located on the side of the Wood Shaper.

(See Figure Y, next page.)

3.Move the Spindle Height Knob (120) to the right to raise the Spindle (105) or to

SKU 95668

For technical questions, please call 1-800-444-3353

PAGE 17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Industrial SHAPER/ROUTER For technical questions or replacement parts, please callGeneral Safety Rules Product SpecificationsSave this Manual Work AreaElectrical Safety Tool USE and Care Service Specific Safety RulesPage Grounding See Outlets for 2-Prong Plug See 3-Prong Plug and OutletProng Plug and Outlet Outlets for 2-Prong Plug Stand Assembly Assembly InstructionsUnpacking See Figure FSee Figure G Optional Table Spacer InstallationInstalling The Safety Guard Installing The FencesInstalling The Spindle 57, 59. See Figure HFigure J Hex Nut. See Figure MRouter Bit Assembly Adjustments InstructionsSee Figures K, L, and M See Figure O57, 59. See Figure Q See Figure PFence Alignment Table Inserts Belt AdjustmentSee Figure R Screws. See Figure SSee Figure T Cutter InstallationCutter Direction See Figure Y, next Setting Spindle HeightSee Figure AA Rub CollarsCutter. See Figure CC Operating InstructionsStart Up To Set Up The Wooden Fences For Straight ShapingFigure DD See Figure DDFreehand Shaping To Set Up The Aluminum Fences For Partial Edge RemovalFigure HH See Figures HHSee Figure JJ Pattern ShapingPlease Read the Following Carefully INSPECTION, MAINTENANCE, and CleaningProblem Possible Reason Possible Solution TroubleshootingDescription Parts ListMotor Wiring DiagramAssembly Diagram Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800 Limited 1 year / 90 Day warranty
Top Page Image Contents