Harbor Freight Tools 95668 operating instructions INSPECTION, MAINTENANCE, and Cleaning

Page 25

INSPECTION, MAINTENANCE, AND CLEANING

1.CAUTION! Always make sure the Power Switch (5) of the Wood Shaper is in its “OFF” position and the unit is unplugged from its electrical outlet prior to performing any inspection, maintenance, or cleaning procedures.

2.Before each use, inspect the general condition of the Wood Shaper. Check for misalignment or binding of moving parts, cracked or broken parts, damaged electrical wiring, and any other condition that may affect the safe operation of the machine. If abnormal noise or vibration occurs, have the problem corrected before further use. Do not use damaged equipment.

3.To clean, use compressed air to blow off any wood shavings, dirt, and debris. Use a clean cloth and mild detergent to wipe off exterior of machine. Do not use solvents. Do not introduce liquids to any electrical part of the unit.

4.To store, keep the machine in a clean, dry, safe location out of reach of children and other unauthorized people.

5.CAUTION! All maintenance, service, or repairs not mentioned in this manual must only be performed by a qualified service technician.

PLEASE READ THE FOLLOWING CAREFULLY

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISKS AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.

REV 07j

SKU 95668

For technical questions, please call 1-800-444-3353

PAGE 25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Industrial SHAPER/ROUTER For technical questions or replacement parts, please callGeneral Safety Rules Product SpecificationsSave this Manual Work AreaElectrical Safety Tool USE and Care Service Specific Safety RulesPage Grounding Prong Plug and Outlet Outlets for 2-Prong Plug See 3-Prong Plug and OutletSee Outlets for 2-Prong Plug Stand Assembly Assembly InstructionsUnpacking See Figure FSee Figure G Optional Table Spacer InstallationInstalling The Safety Guard Installing The FencesInstalling The Spindle 57, 59. See Figure HFigure J Hex Nut. See Figure MRouter Bit Assembly Adjustments InstructionsSee Figures K, L, and M See Figure OFence Alignment See Figure P57, 59. See Figure Q Table Inserts Belt AdjustmentSee Figure R Screws. See Figure SCutter Direction Cutter InstallationSee Figure T See Figure Y, next Setting Spindle HeightSee Figure AA Rub CollarsCutter. See Figure CC Operating InstructionsStart Up To Set Up The Wooden Fences For Straight ShapingFigure DD See Figure DDFreehand Shaping To Set Up The Aluminum Fences For Partial Edge RemovalFigure HH See Figures HHSee Figure JJ Pattern ShapingPlease Read the Following Carefully INSPECTION, MAINTENANCE, and CleaningProblem Possible Reason Possible Solution TroubleshootingDescription Parts ListMotor Wiring DiagramAssembly Diagram Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800 Limited 1 year / 90 Day warranty
Top Page Image Contents