Harbor Freight Tools 95668 operating instructions See Figure DD

Page 21

6.Tighten the Lock Handle (61) to lock the infeed Fence (60) in position.

(See Figure DD.)

		FENCE
	FENCE	(60)
	FENCE	OUTFEED SIDE
	(60)	OUTFEED SIDE
	INFEED SIDE

FIGURE DD

LOCK HANDLE

(61)HAND KNOB

(68)

7.Adjust the outfeed Fence (60) so that it is located as far back from the front of the Work Table (52) as possible. (See Figure DD.)

8.Turn on the Wood Shaper.

9.Using a piece of scrap wood, advance the workpiece 8” into the Cutter and turn off the machine. DO NOT remove the workpiece from the infeed Fence (60).

(See Figure DD.)

10.Once the Cutter has come to a complete stop, adjust the outfeed Fence (60) so that it just touches the newly cut edge of the workpiece. Always follow the direction of feed as shown below. (See Figure EE.)

(GUARD NOT SHOWN FOR CLARITY)

INPUT FEED

DIRECTION OF FEED

OUTPUT FEED

FIGURE EE

11.Check to make sure all Aluminum Fence Lock Handles (61) are tight before proceeding to finish the cut. (See Figure DD.)

SKU 95668

For technical questions, please call 1-800-444-3353

PAGE 21

Image 21

Contents Industrial SHAPER/ROUTER For technical questions or replacement parts, please callGeneral Safety Rules Product SpecificationsSave this Manual Work AreaElectrical Safety Tool USE and Care Service Specific Safety RulesPage Grounding See 3-Prong Plug and Outlet Prong Plug and Outlet Outlets for 2-Prong PlugSee Outlets for 2-Prong Plug Stand Assembly Assembly InstructionsUnpacking See Figure FSee Figure G Optional Table Spacer InstallationInstalling The Safety Guard Installing The FencesInstalling The Spindle 57, 59. See Figure HFigure J Hex Nut. See Figure MRouter Bit Assembly Adjustments InstructionsSee Figures K, L, and M See Figure OSee Figure P Fence Alignment57, 59. See Figure Q Table Inserts Belt AdjustmentSee Figure R Screws. See Figure SCutter Installation Cutter DirectionSee Figure T See Figure Y, next Setting Spindle HeightSee Figure AA Rub CollarsCutter. See Figure CC Operating InstructionsStart Up To Set Up The Wooden Fences For Straight ShapingFigure DD See Figure DDFreehand Shaping To Set Up The Aluminum Fences For Partial Edge RemovalFigure HH See Figures HHSee Figure JJ Pattern ShapingPlease Read the Following Carefully INSPECTION, MAINTENANCE, and CleaningProblem Possible Reason Possible Solution TroubleshootingDescription Parts ListMotor Wiring DiagramAssembly Diagram Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800 Limited 1 year / 90 Day warranty