Harbor Freight Tools 95668 Cutter Direction, See Figure T, Cutter Installation

Page 16

Cutter Direction:

1.The Wood Shaper is capable of operating in two directions by the use of the Forward/Reverse Switch (144). It is very important that the workpiece be fed against the direction of the Cutter rotation. (Cutter not included)

(See Figure T.)

2.When the Forward/Reverse Switch (144) is pointing to the FWD position, the Spindle (105) and Cutter rotate counterclockwise. (See Figure T.)

3.When the Forward/Reverse Switch (144) is pointing to the REV position, the Spindle (105) and Cutter rotate clockwise. (See Figure T.)

4.Always try to operate the Wood Shaper so the wood is cut from the underside. Underside cutting is much safer for the operator because when the wood is cut on the top side, the Cutter can lift and grab the wood and cause possible injury to the operator.

FORWARD/REVERSE SWITCH

(144)

FIGURE T

Cutter Installation:

1.Slide the Cutter (not included) onto the Spindle (105), making sure the rotation is correct for the specific application.

SKU 95668

For technical questions, please call 1-800-444-3353

PAGE 16

Image 16

Contents For technical questions or replacement parts, please call Industrial SHAPER/ROUTERProduct Specifications General Safety RulesSave this Manual Work AreaElectrical Safety Tool USE and Care Specific Safety Rules ServicePage Grounding Prong Plug and Outlet Outlets for 2-Prong Plug See 3-Prong Plug and OutletSee Outlets for 2-Prong Plug Assembly Instructions Stand AssemblyUnpacking See Figure FOptional Table Spacer Installation See Figure GInstalling The Fences Installing The Safety GuardInstalling The Spindle 57, 59. See Figure HHex Nut. See Figure M Figure JAdjustments Instructions Router Bit AssemblySee Figures K, L, and M See Figure OFence Alignment See Figure P57, 59. See Figure Q Belt Adjustment Table InsertsSee Figure R Screws. See Figure SCutter Direction Cutter InstallationSee Figure T Setting Spindle Height See Figure Y, nextRub Collars See Figure AAOperating Instructions Cutter. See Figure CCTo Set Up The Wooden Fences For Straight Shaping Start UpSee Figure DD Figure DDTo Set Up The Aluminum Fences For Partial Edge Removal Freehand ShapingSee Figures HH Figure HHPattern Shaping See Figure JJINSPECTION, MAINTENANCE, and Cleaning Please Read the Following CarefullyTroubleshooting Problem Possible Reason Possible SolutionParts List DescriptionWiring Diagram MotorAssembly Diagram Limited 1 year / 90 Day warranty Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800