Harbor Freight Tools 95668 operating instructions Hex Nut. See Figure M, Figure J

Page 12

2.Thread one end of the Draw Bar (121) into the bottom end of the Spindle (105) approximately 10 to 15 turns until tight. (See Figure J.)

3.Insert the Spindle/Draw Bar assembly into the Spindle Housing (110) from the top side of the Work Table (52). (See Figure K.)

4.Thread the tapered Draw Bar Hex Nut (122) onto the end of the Draw Bar (121) under the Work Table (52), making sure the tapered side of the Hex Nut is facing upward. (See Figure L.)

5.Place a wrench (not included) on the top end of the Spindle (105).

6.Using an open-end wrench (not included), tighten the Draw Bar Hex Nut (122) while holding the Spindle (105) securely. DO NOT over-tighten the Draw Bar

Hex Nut. (See Figure M.)

FIGURE J

FIGURE K

SPINDLE

(105)

DRAW BAR

(121)

SPINDLE HOUSING (110)

FIGURE L	FIGURE M
	SPINDLE (105)

DRAW BAR HEX NUT

(122)

	DRAW BAR HEX NUT
	DRAW BAR HEX NUT
	(122)
				REV 07j
SKU 95668	For technical questions, please call 1-800-444-3353			PAGE 12

Image 12

Contents For technical questions or replacement parts, please call Industrial SHAPER/ROUTERProduct Specifications General Safety RulesSave this Manual Work AreaElectrical Safety Tool USE and Care Specific Safety Rules ServicePage Grounding See 3-Prong Plug and Outlet Prong Plug and Outlet Outlets for 2-Prong PlugSee Outlets for 2-Prong Plug Assembly Instructions Stand AssemblyUnpacking See Figure FOptional Table Spacer Installation See Figure GInstalling The Fences Installing The Safety GuardInstalling The Spindle 57, 59. See Figure HHex Nut. See Figure M Figure JAdjustments Instructions Router Bit AssemblySee Figures K, L, and M See Figure OSee Figure P Fence Alignment57, 59. See Figure Q Belt Adjustment Table InsertsSee Figure R Screws. See Figure SCutter Installation Cutter DirectionSee Figure T Setting Spindle Height See Figure Y, nextRub Collars See Figure AAOperating Instructions Cutter. See Figure CCTo Set Up The Wooden Fences For Straight Shaping Start UpSee Figure DD Figure DDTo Set Up The Aluminum Fences For Partial Edge Removal Freehand ShapingSee Figures HH Figure HHPattern Shaping See Figure JJINSPECTION, MAINTENANCE, and Cleaning Please Read the Following CarefullyTroubleshooting Problem Possible Reason Possible SolutionParts List DescriptionWiring Diagram MotorAssembly Diagram Limited 1 year / 90 Day warranty Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800