Harbor Freight Tools 95668 operating instructions Operating Instructions, Cutter. See Figure CC

Page 19

B.Between two Cutters: This set-up has the advantage of making two profile cuts in a single pass. Although there is a Rub Collar (98, 99, 100) beneath a Cutter, this set-up is safer than the previous set-up. Any lifting of the workpiece will still cause the Cutter to make an uneven cut. A second pass will correct the profile on the bottom edge, but the top profile will still have the gouge from lifting the workpiece into the Cutter. (See Figure BB.)

CUTTER

RUB COLLAR

(98, 99, 100)

BETWEEN

CUTTER

FIGURE BB

C.Below the Cutter: This set-up allows the cut to be viewed by the operator. However, it is also the most dangerous. Any slight lifting of the workpiece will cause the Cutter to make too deep of a cut. There is also increased risk of kickback. It is NOT recommended to shape with a Rub Collar below the

Cutter. (See Figure CC.)

NOT RECOMMENDED

RUB COLLAR				CUTTER


(98, 99, 100)

BELOW

FIGURE CC

OPERATING INSTRUCTIONS

1.Use safety equipment. Always wear ANSI-approved safety impact eye goggles. Dust mask or respirator, and hearing protection must be used for appropriate conditions.

SKU 95668

For technical questions, please call 1-800-444-3353

PAGE 19

Image 19

Contents Industrial SHAPER/ROUTER For technical questions or replacement parts, please callWork Area Product SpecificationsGeneral Safety Rules Save this ManualElectrical Safety Tool USE and Care Service Specific Safety RulesPage Grounding Prong Plug and Outlet Outlets for 2-Prong Plug See 3-Prong Plug and OutletSee Outlets for 2-Prong Plug See Figure F Assembly InstructionsStand Assembly UnpackingSee Figure G Optional Table Spacer Installation57, 59. See Figure H Installing The FencesInstalling The Safety Guard Installing The SpindleFigure J Hex Nut. See Figure MSee Figure O Adjustments InstructionsRouter Bit Assembly See Figures K, L, and MFence Alignment See Figure P57, 59. See Figure Q Screws. See Figure S Belt AdjustmentTable Inserts See Figure RCutter Direction Cutter InstallationSee Figure T See Figure Y, next Setting Spindle HeightSee Figure AA Rub CollarsCutter. See Figure CC Operating InstructionsStart Up To Set Up The Wooden Fences For Straight ShapingFigure DD See Figure DDFreehand Shaping To Set Up The Aluminum Fences For Partial Edge RemovalFigure HH See Figures HHSee Figure JJ Pattern ShapingPlease Read the Following Carefully INSPECTION, MAINTENANCE, and CleaningProblem Possible Reason Possible Solution TroubleshootingDescription Parts ListMotor Wiring DiagramAssembly Diagram Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800 Limited 1 year / 90 Day warranty