Harbor Freight Tools 95668 operating instructions Rub Collars, See Figure AA

Page 18

the left to lower the Spindle (105). (See Figure Z.)

4.Retighten the Spindle Hand Knob (92) on the side of the Wood Shaper. DO NOT overtighten the Knob. Only a small amount of tension is needed to keep the Spindle (105) from moving during operation. (See Figure Y.)

FIGURE Y

FIGURE Z

SPINDLE

HAND KNOB

(92)

SPINDLE

HEIGHT KNOB

(120)

Rub Collars:

1.When shaping workpieces that have irregular shapes, Rub Collars (98, 99, 100) are a necessity. Some examples of when you would use a Rub Collar are raising arched or tombstone door panels, round table tops, or any other cut that needs to have its depth of cut limited.

2.There are three set-up positions for Rub Collars (98, 99, 100):

A. Above the Cutter: This set-up is the safest and produces a most consistent result. The only drawback is that the cut is on the underside of the workpiece, out of view of the operator. However, if the workpiece lifts off the

Work Table (52) you simply run it through a second time to finish the cut.

(See Figure AA.)

RUB COLLAR

(98, 99, 100)

ABOVE

CUTTER

FIGURE AA

SKU 95668

For technical questions, please call 1-800-444-3353

PAGE 18

Image 18

Contents For technical questions or replacement parts, please call Industrial SHAPER/ROUTERSave this Manual Product SpecificationsGeneral Safety Rules Work AreaElectrical Safety Tool USE and Care Specific Safety Rules ServicePage Grounding See 3-Prong Plug and Outlet Prong Plug and Outlet Outlets for 2-Prong PlugSee Outlets for 2-Prong Plug Unpacking Assembly InstructionsStand Assembly See Figure FOptional Table Spacer Installation See Figure GInstalling The Spindle Installing The FencesInstalling The Safety Guard 57, 59. See Figure HHex Nut. See Figure M Figure JSee Figures K, L, and M Adjustments InstructionsRouter Bit Assembly See Figure OSee Figure P Fence Alignment57, 59. See Figure Q See Figure R Belt AdjustmentTable Inserts Screws. See Figure SCutter Installation Cutter DirectionSee Figure T Setting Spindle Height See Figure Y, nextRub Collars See Figure AAOperating Instructions Cutter. See Figure CCTo Set Up The Wooden Fences For Straight Shaping Start UpSee Figure DD Figure DDTo Set Up The Aluminum Fences For Partial Edge Removal Freehand ShapingSee Figures HH Figure HHPattern Shaping See Figure JJINSPECTION, MAINTENANCE, and Cleaning Please Read the Following CarefullyTroubleshooting Problem Possible Reason Possible SolutionParts List DescriptionWiring Diagram MotorAssembly Diagram Limited 1 year / 90 Day warranty Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800