Harbor Freight Tools 95668 operating instructions Specific Safety Rules, Service

Page 5

SERVICE

1.Tool service must be performed only by qualified repair personnel. Service or maintenance performed by unqualified personnel could result in a risk of injury.

2.When servicing a tool, use only identical replacement parts. Follow instructions in the “Inspection, Maintenance, And Cleaning” section of this manual. Use of unauthorized parts or failure to follow maintenance instructions may create a risk of electric shock or injury.

SPECIFIC SAFETY RULES

1.Maintain labels and nameplates on the Wood Shaper. These carry important information. If unreadable or missing, contact Harbor Freight Tools for a replacement.

2.Avoid unintentional starting. Make sure you are prepared to begin work before turning on the Wood Shaper.

3.Do not force the Wood Shaper. This tool will do the work better and safer at the speed and capacity for which it was designed.

4.WARNING! Keep hands and fingers away from the cutting area. Use a “push stick” (not included) when necessary.

5.Never leave the Wood Shaper unattended when it is plugged into an electrical outlet. Always unplug the unit from its electrical outlet before leaving.

6.Industrial applications must follow OSHA guidelines.

7.Never stand on the Wood Shaper. Serious injury could result if the unit is tipped.

8.Always unplug the Wood Shaper from its power supply source before performing any inspection, maintenance, or cleaning procedures.

9.Keep all guards in place and in proper working order.

10.Never place your hands within 12 inches of the Cutters. Never pass your hands directly over or in front of the Cutter. As one hand approaches the 12 inch radius point, move it in an arc motion away from the Cutter to the outfeed side and reposition that hand more than 12 inches beyond the Cutter.

11.Do not shape stock shorter than 12 inches without special fixtures or jigs

(not included). Where practical, shape longer stock and cut to size.

SKU 95668

For technical questions, please call 1-800-444-3353

PAGE 5

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Industrial SHAPER/ROUTER For technical questions or replacement parts, please callGeneral Safety Rules Product SpecificationsSave this Manual Work AreaElectrical Safety Tool USE and Care Service Specific Safety RulesPage Grounding See Outlets for 2-Prong Plug See 3-Prong Plug and OutletProng Plug and Outlet Outlets for 2-Prong Plug Stand Assembly Assembly InstructionsUnpacking See Figure FSee Figure G Optional Table Spacer InstallationInstalling The Safety Guard Installing The FencesInstalling The Spindle 57, 59. See Figure HFigure J Hex Nut. See Figure MRouter Bit Assembly Adjustments InstructionsSee Figures K, L, and M See Figure O57, 59. See Figure Q See Figure PFence Alignment Table Inserts Belt AdjustmentSee Figure R Screws. See Figure SSee Figure T Cutter InstallationCutter Direction See Figure Y, next Setting Spindle HeightSee Figure AA Rub CollarsCutter. See Figure CC Operating InstructionsStart Up To Set Up The Wooden Fences For Straight ShapingFigure DD See Figure DDFreehand Shaping To Set Up The Aluminum Fences For Partial Edge RemovalFigure HH See Figures HHSee Figure JJ Pattern ShapingPlease Read the Following Carefully INSPECTION, MAINTENANCE, and CleaningProblem Possible Reason Possible Solution TroubleshootingDescription Parts ListMotor Wiring DiagramAssembly Diagram Mission Oaks Blvd. PO Box 6009 Camarillo, CA 93011 800 Limited 1 year / 90 Day warranty
Top Page Image Contents