Compatible Systems 1220I manual Network Installation, Placing the Router

Chapter 3 - Network Installation 9

Chapter 3 - Network Installation

MicroRouter 1220i Back Panel

This section of the manual describes how to connect the MicroRouter 1220i to your Ethernet network and your wide area communications device(s). In summary, the steps for installation are:

1.Make sure the router is powered down and not plugged to any power source.

2.Connect the router to the Ethernet networks.

3.Connect the router’s secondary port to a wide area line communica- tions device (if used).

4.Power up the line communications device (if used).

Note: You should either wait to connect a synchronous line device vsuch as a CSU/DSU until after the interface has been configured as a synchronous port, or power up the router before powering up the CSU/DSU. (See Chapter 6 - Basic Configuration Guide for more infor- mation on configuring the router.)

5. Plug in the power cable and power up the router.

Placing the Router

The MicroRouter 1220i is meant to be left stand-alone on a desktop or equipment table.

Note: When stacking other equipment on the MicroRouter 1220i, do vnot exceed 25 pounds of evenly distributed weight on top of the router. Additional weight may bend the case.