Compatible Systems 1220I manual Frame Relay Configuration, Frame Relay Dlci Mappings

Suggested for IPX

If you plan to use dial-on-demand for this link, you should set the update method to “triggered” to avoid the link being brought up by transmission of IPX RIP information. You should only use triggered operation when you are connecting to another Compatible Systems router at the other end.

When you set up an on-demand link with IPX, you should carefully monitor link usage to determine whether the link is being activated only when it is needed. Additional router configuration will be required for many networks in order to achieve optimal link usage.

•Set update method

CV: Use the IPX Routing: WAN Dialog Box.

TB: Use configure and set the Updates keyword in the IPX WAN 0 (and/or WAN 1) section.

Frame Relay Configuration

This section covers the settings required for Frame Relay operation of the MicroRouter 1220i WAN interfaces. In general, the parameters listed here should be set for each WAN interface on which you plan to use Frame Relay.

Link Configuration

Frame Relay is presently supported in the MicroRouter 1220i only via dedicated line operation.

•Set Dedicated connection

•Set Frame Relay connection

CV: Use the Link Configuration: WAN Dialog Box.

TB: Use configure to set the Mode and ConnectMode keywords in the Link Config WAN 0 (and/or WAN 1) section.

Suggested for Dedicated/Leased Line Operation

Dedicated line operation generally does not require additional parame- ters for operation.

Frame Relay DLCI Mappings

If you are connecting to another Compatible Systems router, this infor- mation is not required for Frame Relay operation. Compatible Systems