Compatible Systems 1220I manual Getting Started, RS-232 Interface

Page 14

8	Chapter 2 - Getting Started

RS-232 Interface

The MicroRouter 1220i includes one DB-25 to DB-25 RS-232 sync/async cable. This cable supports RS-232 asynchronous modems, synchronous leased and switched 56K CSU/DSUs, and ISDN Terminal Adapters. It can also be used to connect the router’s auxiliary interface to a PC running terminal emulation software, or to a dumb terminal.

Note: Please use only the supplied DB-25cable when connecting vyour line communication device to the MicroRouter 1220i’s RS-232 interface. The cables provided with other equipment may not have all of the same internal connections.

Image 14

Contents MicroRouter Installation Guide Page Getting Started Network InstallationIntroduction Basic Configuration Guide CompatiView Software InstallationAppendix a Shipping Defaults Appendix B Connector and Cable Pin OutsSystems Appendix E Terms and Conditions Introduction IntroductionAbout the MicroRouter MicroRouter 1220i Installation Overview Getting StartedCommand Line Preparation Introduction Network InstallationCompatiView Software Installation Basic Configuration GuidePage Few Notes Warranty and ServiceGetting Started Please Read The ManualsSupplied with the MicroRouter Needed For InstallationWhat You Will Need To Get Started Ethernet Connection RequirementsInterface Telco Line Connection RequirementsGetting Started 10Base-T Twisted-Pair Ethernet RS-232 Interface Network Installation Placing the RouterConnecting to Twisted-Pair Ethernet Connecting the Router to the EthernetConnecting a Line Device to MicroRouter Connecting Devices to the V.35 InterfaceConnecting an Out-of-Band Management Console Connecting Devices to the RS-232C InterfacePowering Up the Router System Requirements Installation and OperationCompatiView for Windows Transport Protocols and CompatiView Command Line Management Out-of-Band Command Line ManagementSetting Up Telnet Operation Command Line ManagementCommand Line Management Page Basic Configuration Guide Required for IP Ethernet Interface ConfigurationIP Protocol Suggested for IPIPX Protocol WAN Interface ConfigurationPhysical Communications Settings Required for IPXSuggested for Dedicated/Leased Line Operation Link ConfigurationRequired for Dedicated/Leased Line Operation Required for Dial-On-Demand OperationIP Protocol Frame Relay Configuration Frame Relay Dlci MappingsRequired for IP Numbered Interface Required for IP Unnumbered InterfaceIPX Protocol Saving a Configuration File to Flash ROM Smds AddressingPage WAN Interfaces Appendix a Shipping DefaultsEthernet Interfaces WAN 0 Link & Physical Defaults RS-232 WAN 1 Link & Physical DefaultsAppendix B Connector and Cable Pin Outs Pin Outs for V.35 Female Connector DTEAppendix B Connector and Cable Pin Outs Other Indicators on All LED Bars Power On, No TrafficEthernet Traffic Indicators Ethernet LED Bars Panic IndicatorsMicroRouter 1220i Switch Settings Appendix C LED Patterns and Test Switch SettingsAppendix D Downloading Software From Compatible Systems Page Appendix E Terms Conditions Appendix E Terms and ConditionsAppendix E Terms and Conditions Appendix E Terms and Conditions