Compatible Systems 1220I Introduction Network Installation, CompatiView Software Installation

Page 9

Chapter 1 - Introduction	3

Chapter 3 - Network Installation

Here you will find step-by-step instructions on how to physically install the MicroRouter 1220i and connect it to your local Ethernets and your wide area network(s). Instructions are included for twisted-pair Ethernet environments and fractional or full T1’s, as well as modems, 56K CSU/DSUs, and ISDN terminal adapters.

Chapter 4 - CompatiView Software Installation

This part of the manual describes how to install CompatiView, Compat- ible Systems’ GUI (Graphical User Interface) management software which is included with your router.

Chapter 5 - Command Line Preparation

This part of the manual provides basic instructions on setting up command line management and text-based configuration.

Chapter 6 - Basic Configuration Guide

This section provides a list of parameters that must be entered into a router for proper operation.

Appendices

This part of the manual includes additional information that might be of interest to you such as technical specifications, default settings (including the default factory password) and instructions for down- loading current software.

Image 9

Contents MicroRouter Installation Guide Page Network Installation IntroductionGetting Started CompatiView Software Installation Basic Configuration GuideAppendix B Connector and Cable Pin Outs Appendix a Shipping DefaultsSystems Appendix E Terms and Conditions Introduction About the MicroRouterIntroduction Getting Started MicroRouter 1220i Installation OverviewCompatiView Software Installation Introduction Network InstallationCommand Line Preparation Basic Configuration GuidePage Getting Started Warranty and ServiceFew Notes Please Read The ManualsWhat You Will Need To Get Started Needed For InstallationSupplied with the MicroRouter Ethernet Connection RequirementsTelco Line Connection Requirements Getting Started 10Base-T Twisted-Pair EthernetInterface RS-232 Interface Placing the Router Network InstallationConnecting a Line Device to MicroRouter Connecting the Router to the EthernetConnecting to Twisted-Pair Ethernet Connecting Devices to the V.35 InterfaceConnecting Devices to the RS-232C Interface Connecting an Out-of-Band Management ConsolePowering Up the Router Installation and Operation CompatiView for WindowsSystem Requirements Transport Protocols and CompatiView Out-of-Band Command Line Management Command Line ManagementCommand Line Management Setting Up Telnet OperationCommand Line Management Page Basic Configuration Guide IP Protocol Ethernet Interface ConfigurationRequired for IP Suggested for IPPhysical Communications Settings WAN Interface ConfigurationIPX Protocol Required for IPXRequired for Dedicated/Leased Line Operation Link ConfigurationSuggested for Dedicated/Leased Line Operation Required for Dial-On-Demand OperationIP Protocol Frame Relay Dlci Mappings Frame Relay ConfigurationRequired for IP Unnumbered Interface Required for IP Numbered InterfaceIPX Protocol Smds Addressing Saving a Configuration File to Flash ROMPage Appendix a Shipping Defaults Ethernet InterfacesWAN Interfaces RS-232 WAN 1 Link & Physical Defaults WAN 0 Link & Physical DefaultsPin Outs for V.35 Female Connector DTE Appendix B Connector and Cable Pin OutsAppendix B Connector and Cable Pin Outs Ethernet Traffic Indicators Ethernet LED Bars Power On, No TrafficOther Indicators on All LED Bars Panic IndicatorsAppendix C LED Patterns and Test Switch Settings MicroRouter 1220i Switch SettingsAppendix D Downloading Software From Compatible Systems Page Appendix E Terms and Conditions Appendix E Terms ConditionsAppendix E Terms and Conditions Appendix E Terms and Conditions