Compatible Systems 1220I Appendix a Shipping Defaults, Appendix B Connector and Cable Pin Outs

Page 5

Suggested for IPX	24
Link Configuration	24
Suggested for Dedicated/Leased Line Operation	24
Frame Relay DLCI Mappings	24
IP Protocol	25
Required for IP	25
Required for IP Numbered Interface	25
Required for IP Unnumbered Interface	25
Suggested for IP	26
IPX Protocol	26
Required for IPX	26
Suggested for IPX	26
Link Configuration	27
SMDS Addressing	27
SAVING A CONFIGURATION FILE TO FLASH ROM	27

Appendix A - Shipping Defaults	29
Ethernet Interfaces	29
IP Routing Defaults	29
IP Bridging Defaults	29
IPX Routing Defaults	29
IPX Bridging Defaults	29
WAN Interfaces	29
IP Defaults	29
IPX Defaults	29
V.35 (WAN 0) Link & Physical Defaults	30
RS-232 (WAN 1) Link & Physical Defaults	30

Appendix B - Connector and Cable Pin Outs	31
Pin Outs for V.35 Female Connector (DTE)	31
Pin Outs for DB-25 Male to DB-25 Female RS-232 Data &
Console Cable	32

iii

Image 5

Contents MicroRouter Installation Guide Page Getting Started Network InstallationIntroduction CompatiView Software Installation Basic Configuration GuideAppendix B Connector and Cable Pin Outs Appendix a Shipping DefaultsSystems Appendix E Terms and Conditions Introduction IntroductionAbout the MicroRouter Getting Started MicroRouter 1220i Installation OverviewCompatiView Software Installation Introduction Network InstallationCommand Line Preparation Basic Configuration GuidePage Getting Started Warranty and ServiceFew Notes Please Read The ManualsWhat You Will Need To Get Started Needed For InstallationSupplied with the MicroRouter Ethernet Connection RequirementsInterface Telco Line Connection RequirementsGetting Started 10Base-T Twisted-Pair Ethernet RS-232 Interface Placing the Router Network InstallationConnecting a Line Device to MicroRouter Connecting the Router to the EthernetConnecting to Twisted-Pair Ethernet Connecting Devices to the V.35 InterfaceConnecting Devices to the RS-232C Interface Connecting an Out-of-Band Management ConsolePowering Up the Router System Requirements Installation and OperationCompatiView for Windows Transport Protocols and CompatiView Out-of-Band Command Line Management Command Line ManagementCommand Line Management Setting Up Telnet OperationCommand Line Management Page Basic Configuration Guide IP Protocol Ethernet Interface ConfigurationRequired for IP Suggested for IPPhysical Communications Settings WAN Interface ConfigurationIPX Protocol Required for IPXRequired for Dedicated/Leased Line Operation Link ConfigurationSuggested for Dedicated/Leased Line Operation Required for Dial-On-Demand OperationIP Protocol Frame Relay Dlci Mappings Frame Relay ConfigurationRequired for IP Unnumbered Interface Required for IP Numbered InterfaceIPX Protocol Smds Addressing Saving a Configuration File to Flash ROMPage WAN Interfaces Appendix a Shipping DefaultsEthernet Interfaces RS-232 WAN 1 Link & Physical Defaults WAN 0 Link & Physical DefaultsPin Outs for V.35 Female Connector DTE Appendix B Connector and Cable Pin OutsAppendix B Connector and Cable Pin Outs Ethernet Traffic Indicators Ethernet LED Bars Power On, No TrafficOther Indicators on All LED Bars Panic IndicatorsAppendix C LED Patterns and Test Switch Settings MicroRouter 1220i Switch SettingsAppendix D Downloading Software From Compatible Systems Page Appendix E Terms and Conditions Appendix E Terms ConditionsAppendix E Terms and Conditions Appendix E Terms and Conditions