Compatible Systems 1220I manual Appendix B Connector and Cable Pin Outs

Page 38

32	Appendix B - Connector and Cable Pin Outs

Pin Outs for DB-25 Male to DB-25 Female RS-232 Data & Console Cable

The cable supplied with the MicroRouter 1220i is twenty-five conduc- tors, straight through. Connections on both the auxiliary interface and the data interface follow the standard RS-232 pin outs. Note that the data interface may be set for synchronous operation and in this mode the data interface will use the clock lines provided by RS-232.

Image 38

Contents

MicroRouter Installation Guide Page Getting Started Network InstallationIntroduction Basic Configuration Guide CompatiView Software InstallationAppendix a Shipping Defaults Appendix B Connector and Cable Pin OutsSystems Appendix E Terms and Conditions Introduction IntroductionAbout the MicroRouter MicroRouter 1220i Installation Overview Getting StartedCommand Line Preparation Introduction Network InstallationCompatiView Software Installation Basic Configuration GuidePage Few Notes Warranty and ServiceGetting Started Please Read The ManualsSupplied with the MicroRouter Needed For InstallationWhat You Will Need To Get Started Ethernet Connection RequirementsInterface Telco Line Connection RequirementsGetting Started 10Base-T Twisted-Pair Ethernet RS-232 Interface Network Installation Placing the RouterConnecting to Twisted-Pair Ethernet Connecting the Router to the EthernetConnecting a Line Device to MicroRouter Connecting Devices to the V.35 InterfaceConnecting an Out-of-Band Management Console Connecting Devices to the RS-232C InterfacePowering Up the Router System Requirements Installation and OperationCompatiView for Windows Transport Protocols and CompatiView Command Line Management Out-of-Band Command Line ManagementSetting Up Telnet Operation Command Line ManagementCommand Line Management Page Basic Configuration Guide Required for IP Ethernet Interface ConfigurationIP Protocol Suggested for IPIPX Protocol WAN Interface ConfigurationPhysical Communications Settings Required for IPXSuggested for Dedicated/Leased Line Operation Link ConfigurationRequired for Dedicated/Leased Line Operation Required for Dial-On-Demand OperationIP Protocol Frame Relay Configuration Frame Relay Dlci MappingsRequired for IP Numbered Interface Required for IP Unnumbered InterfaceIPX Protocol Saving a Configuration File to Flash ROM Smds AddressingPage WAN Interfaces Appendix a Shipping DefaultsEthernet Interfaces WAN 0 Link & Physical Defaults RS-232 WAN 1 Link & Physical DefaultsAppendix B Connector and Cable Pin Outs Pin Outs for V.35 Female Connector DTEAppendix B Connector and Cable Pin Outs Other Indicators on All LED Bars Power On, No TrafficEthernet Traffic Indicators Ethernet LED Bars Panic IndicatorsMicroRouter 1220i Switch Settings Appendix C LED Patterns and Test Switch SettingsAppendix D Downloading Software From Compatible Systems Page Appendix E Terms Conditions Appendix E Terms and ConditionsAppendix E Terms and Conditions Appendix E Terms and Conditions