Compatible Systems 1220I manual Basic Configuration Guide, CompatiView Software Installation

Page 4

Chapter 4 - CompatiView Software Installation

13

COMPATIVIEW FOR WINDOWS

13

System Requirements

13

Installation and Operation

13

Transport Protocols and CompatiView

14

Chapter 5 - Command Line Management

15

OUT-OF-BANDCOMMAND LINE MANAGEMENT

15

TEMPORARILY RECONFIGURING A HOST FOR COMMAND LINE

 

MANAGEMENT

15

SETTING UP TELNET OPERATION

16

Chapter 6 - Basic Configuration Guide

19

ETHERNET INTERFACE CONFIGURATION

20

IP Protocol

20

Required for IP

20

Suggested for IP

20

IPX Protocol

21

Required for IPX

21

Suggested for IPX

21

WAN INTERFACE CONFIGURATION

21

Physical Communications Settings

21

Link Configuration

22

Required for Dedicated/Leased Line Operation

22

Suggested for Dedicated/Leased Line Operation

22

Required for Dial-On-Demand Operation

22

Suggested for Dial-On-Demand Operation

22

IP Protocol

23

Required for IP

23

Suggested for IP

23

IPX Protocol

23

Required for IPX

23

ii

Image 4 Contents
MicroRouter Installation Guide Page Introduction Network InstallationGetting Started Basic Configuration Guide CompatiView Software InstallationAppendix a Shipping Defaults Appendix B Connector and Cable Pin OutsSystems Appendix E Terms and Conditions About the MicroRouter IntroductionIntroduction MicroRouter 1220i Installation Overview Getting StartedIntroduction Network Installation CompatiView Software InstallationCommand Line Preparation Basic Configuration GuidePage Warranty and Service Getting StartedFew Notes Please Read The ManualsNeeded For Installation What You Will Need To Get StartedSupplied with the MicroRouter Ethernet Connection RequirementsGetting Started 10Base-T Twisted-Pair Ethernet Telco Line Connection RequirementsInterface RS-232 Interface Network Installation Placing the RouterConnecting the Router to the Ethernet Connecting a Line Device to MicroRouterConnecting to Twisted-Pair Ethernet Connecting Devices to the V.35 InterfaceConnecting an Out-of-Band Management Console Connecting Devices to the RS-232C InterfacePowering Up the Router CompatiView for Windows Installation and OperationSystem Requirements Transport Protocols and CompatiView Command Line Management Out-of-Band Command Line ManagementSetting Up Telnet Operation Command Line ManagementCommand Line Management Page Basic Configuration Guide Ethernet Interface Configuration IP ProtocolRequired for IP Suggested for IPWAN Interface Configuration Physical Communications SettingsIPX Protocol Required for IPXLink Configuration Required for Dedicated/Leased Line OperationSuggested for Dedicated/Leased Line Operation Required for Dial-On-Demand OperationIP Protocol Frame Relay Configuration Frame Relay Dlci MappingsRequired for IP Numbered Interface Required for IP Unnumbered InterfaceIPX Protocol Saving a Configuration File to Flash ROM Smds AddressingPage Ethernet Interfaces Appendix a Shipping DefaultsWAN Interfaces WAN 0 Link & Physical Defaults RS-232 WAN 1 Link & Physical DefaultsAppendix B Connector and Cable Pin Outs Pin Outs for V.35 Female Connector DTEAppendix B Connector and Cable Pin Outs Power On, No Traffic Ethernet Traffic Indicators Ethernet LED BarsOther Indicators on All LED Bars Panic IndicatorsMicroRouter 1220i Switch Settings Appendix C LED Patterns and Test Switch SettingsAppendix D Downloading Software From Compatible Systems Page Appendix E Terms Conditions Appendix E Terms and ConditionsAppendix E Terms and Conditions Appendix E Terms and Conditions