Compatible Systems 1220I manual Link Configuration, Required for Dedicated/Leased Line Operation

22 Chapter 6 - Basic Configuration Guide

PPP Configuration

This section covers the settings required for PPP (point-to-point) protocol operation of the WAN interfaces.

Link Configuration

Required for Dedicated/Leased Line Operation

Dedicated line operation is the simplest to set up.

•Set Dedicated connection

•Set PPP connection

CV: Use the Link Configuration: WAN 1 Dialog Box.

TB: Use configure and set the Mode and ConnectMode keywords in the Link Config WAN 0 (and/or WAN 1) section.

Suggested for Dedicated/Leased Line Operation

Dedicated line operation generally does not require additional parame- ters for operation.

Required for Dial-On-Demand Operation

Incoming dial-on-demand operation requires only slightly more infor- mation than dedicated line setup. Outgoing dial-on-demand requires additional information (see the suggested settings below).

•Set dial-up connection

•Set PPP connection

•Set to allow dial-in and/or dial-out

CV: Use the Link Configuration: WAN Dialog Box.

TB: Use configure and set the Mode, ConnectMode, DialIn and/or DialOut keywords in the Link Config WAN 0 (and/or WAN 1)

section.

Suggested for Dial-On-Demand Operation

This mode of operation is only supported on the WAN 1 RS-232 inter- face. Outgoing dial-on-demand requires some additional information.

•Create dial-out script

•Set dialing method

•Set dial-out script to be used

•Set inactivity time

CV: Use the Link Configuration: WAN 1 Dialog Box to set the dialing