Compatible Systems 1220I manual Appendix a Shipping Defaults, Ethernet Interfaces, WAN Interfaces

Page 35

Appendix A - Shipping Defaults

29

Appendix A - Shipping Defaults

Ethernet Interfaces

IP Routing Defaults

Off, both interfaces

IP Bridging Defaults

On, both interfaces

Address: 198.41.12.1

Subnet Mask: 255.255.255.0

Broadcast Address: 198.41.12.255

IP RIP off

IPX Routing Defaults

802.3 on, autoseeding, both interfaces

802.2 on, autoseeding, both interfaces

Type II off, both interfaces

802.2 SNAP off, both interfaces

IPX Bridging Defaults

Off, both interfaces

WAN Interfaces

IP Defaults

On

Unnumbered interface

RIP off

Van Jacobson compression off

IPX Defaults

On

Unnumbered interface

Image 35
Contents MicroRouter Installation Guide Page Getting Started Network InstallationIntroduction CompatiView Software Installation Basic Configuration GuideAppendix B Connector and Cable Pin Outs Appendix a Shipping DefaultsSystems Appendix E Terms and Conditions Introduction IntroductionAbout the MicroRouter Getting Started MicroRouter 1220i Installation OverviewBasic Configuration Guide Introduction Network InstallationCompatiView Software Installation Command Line PreparationPage Please Read The Manuals Warranty and ServiceGetting Started Few NotesEthernet Connection Requirements Needed For InstallationWhat You Will Need To Get Started Supplied with the MicroRouterInterface Telco Line Connection RequirementsGetting Started 10Base-T Twisted-Pair Ethernet RS-232 Interface Placing the Router Network InstallationConnecting Devices to the V.35 Interface Connecting the Router to the EthernetConnecting a Line Device to MicroRouter Connecting to Twisted-Pair EthernetConnecting Devices to the RS-232C Interface Connecting an Out-of-Band Management ConsolePowering Up the Router System Requirements Installation and OperationCompatiView for Windows Transport Protocols and CompatiView Out-of-Band Command Line Management Command Line ManagementCommand Line Management Setting Up Telnet OperationCommand Line Management Page Basic Configuration Guide Suggested for IP Ethernet Interface ConfigurationIP Protocol Required for IPRequired for IPX WAN Interface ConfigurationPhysical Communications Settings IPX ProtocolRequired for Dial-On-Demand Operation Link ConfigurationRequired for Dedicated/Leased Line Operation Suggested for Dedicated/Leased Line OperationIP Protocol Frame Relay Dlci Mappings Frame Relay ConfigurationRequired for IP Unnumbered Interface Required for IP Numbered InterfaceIPX Protocol Smds Addressing Saving a Configuration File to Flash ROMPage WAN Interfaces Appendix a Shipping DefaultsEthernet Interfaces RS-232 WAN 1 Link & Physical Defaults WAN 0 Link & Physical DefaultsPin Outs for V.35 Female Connector DTE Appendix B Connector and Cable Pin OutsAppendix B Connector and Cable Pin Outs Panic Indicators Power On, No TrafficEthernet Traffic Indicators Ethernet LED Bars Other Indicators on All LED BarsAppendix C LED Patterns and Test Switch Settings MicroRouter 1220i Switch SettingsAppendix D Downloading Software From Compatible Systems Page Appendix E Terms and Conditions Appendix E Terms ConditionsAppendix E Terms and Conditions Appendix E Terms and Conditions