Compatible Systems 1220I manual Introduction, Getting Started, Network Installation

Page 3

Chapter 1 - Introduction

1

ABOUT THE MICROROUTER 1220I

1

A NOTE ABOUT FIREWALLS

1

A NOTE ABOUT ON-DEMANDINTERNETWORKING

1

MICROROUTER 1220I INSTALLATION OVERVIEW

2

Chapter 2 - Getting Started

5

A FEW NOTES

5

Please Read The Manuals

5

Warranty and Service

5

Getting Help With the MicroRouter 1220i

5

WHAT YOU WILL NEED TO GET STARTED

6

Supplied with the MicroRouter 1220i

6

Needed For Installation

6

Ethernet Connection Requirements

6

10Base-TTwisted-Pair Ethernet

7

Telco Line Connection Requirements

7

V.35 Interface

7

RS-232 Interface

8

Chapter 3 - Network Installation

9

PLACING THE ROUTER

9

CONNECTING THE ROUTER TO THE ETHERNET

10

Connecting to Twisted-Pair Ethernet

10

CONNECTING A LINE DEVICE TO THE MICROROUTER 1220I

10

Connecting Devices to the V.35 Interface

10

Connecting Devices to the RS-232C Interface

11

CONNECTING AN OUT-OF-BANDMANAGEMENT CONSOLE

11

POWERING UP THE ROUTER

12

i

Image 3
Contents MicroRouter Installation Guide Page Network Installation IntroductionGetting Started CompatiView Software Installation Basic Configuration GuideAppendix B Connector and Cable Pin Outs Appendix a Shipping DefaultsSystems Appendix E Terms and Conditions Introduction About the MicroRouterIntroduction Getting Started MicroRouter 1220i Installation OverviewBasic Configuration Guide Introduction Network InstallationCompatiView Software Installation Command Line PreparationPage Please Read The Manuals Warranty and ServiceGetting Started Few NotesEthernet Connection Requirements Needed For InstallationWhat You Will Need To Get Started Supplied with the MicroRouterTelco Line Connection Requirements Getting Started 10Base-T Twisted-Pair EthernetInterface RS-232 Interface Placing the Router Network InstallationConnecting Devices to the V.35 Interface Connecting the Router to the EthernetConnecting a Line Device to MicroRouter Connecting to Twisted-Pair EthernetConnecting Devices to the RS-232C Interface Connecting an Out-of-Band Management ConsolePowering Up the Router Installation and Operation CompatiView for WindowsSystem Requirements Transport Protocols and CompatiView Out-of-Band Command Line Management Command Line ManagementCommand Line Management Setting Up Telnet OperationCommand Line Management Page Basic Configuration Guide Suggested for IP Ethernet Interface ConfigurationIP Protocol Required for IPRequired for IPX WAN Interface ConfigurationPhysical Communications Settings IPX ProtocolRequired for Dial-On-Demand Operation Link ConfigurationRequired for Dedicated/Leased Line Operation Suggested for Dedicated/Leased Line OperationIP Protocol Frame Relay Dlci Mappings Frame Relay ConfigurationRequired for IP Unnumbered Interface Required for IP Numbered InterfaceIPX Protocol Smds Addressing Saving a Configuration File to Flash ROMPage Appendix a Shipping Defaults Ethernet InterfacesWAN Interfaces RS-232 WAN 1 Link & Physical Defaults WAN 0 Link & Physical DefaultsPin Outs for V.35 Female Connector DTE Appendix B Connector and Cable Pin OutsAppendix B Connector and Cable Pin Outs Panic Indicators Power On, No TrafficEthernet Traffic Indicators Ethernet LED Bars Other Indicators on All LED BarsAppendix C LED Patterns and Test Switch Settings MicroRouter 1220i Switch SettingsAppendix D Downloading Software From Compatible Systems Page Appendix E Terms and Conditions Appendix E Terms ConditionsAppendix E Terms and Conditions Appendix E Terms and Conditions