Compatible Systems 1220I manual Systems Appendix E Terms and Conditions

Page 6

Appendix C - LED Patterns and Test Switch Settings

33

MicroRouter 1220i LED Patterns

33

Power On, No Traffic

33

Ethernet Traffic Indicators (Ethernet LED Bars)

33

Other Indicators (on All LED Bars)

33

Panic Indicators

33

MicroRouter 1220i Switch Settings

34

Appendix D - Downloading Software From Compatible

Systems

35

 

 

Appendix E - Terms and Conditions

37

 

 

iv

Image 6
Contents MicroRouter Installation Guide Page Network Installation IntroductionGetting Started Basic Configuration Guide CompatiView Software InstallationAppendix a Shipping Defaults Appendix B Connector and Cable Pin OutsSystems Appendix E Terms and Conditions Introduction About the MicroRouterIntroduction MicroRouter 1220i Installation Overview Getting StartedCommand Line Preparation Introduction Network InstallationCompatiView Software Installation Basic Configuration GuidePage Few Notes Warranty and ServiceGetting Started Please Read The ManualsSupplied with the MicroRouter Needed For InstallationWhat You Will Need To Get Started Ethernet Connection RequirementsTelco Line Connection Requirements Getting Started 10Base-T Twisted-Pair EthernetInterface RS-232 Interface Network Installation Placing the RouterConnecting to Twisted-Pair Ethernet Connecting the Router to the EthernetConnecting a Line Device to MicroRouter Connecting Devices to the V.35 InterfaceConnecting an Out-of-Band Management Console Connecting Devices to the RS-232C InterfacePowering Up the Router Installation and Operation CompatiView for WindowsSystem Requirements Transport Protocols and CompatiView Command Line Management Out-of-Band Command Line ManagementSetting Up Telnet Operation Command Line ManagementCommand Line Management Page Basic Configuration Guide Required for IP Ethernet Interface ConfigurationIP Protocol Suggested for IPIPX Protocol WAN Interface ConfigurationPhysical Communications Settings Required for IPXSuggested for Dedicated/Leased Line Operation Link ConfigurationRequired for Dedicated/Leased Line Operation Required for Dial-On-Demand OperationIP Protocol Frame Relay Configuration Frame Relay Dlci MappingsRequired for IP Numbered Interface Required for IP Unnumbered InterfaceIPX Protocol Saving a Configuration File to Flash ROM Smds AddressingPage Appendix a Shipping Defaults Ethernet InterfacesWAN Interfaces WAN 0 Link & Physical Defaults RS-232 WAN 1 Link & Physical DefaultsAppendix B Connector and Cable Pin Outs Pin Outs for V.35 Female Connector DTEAppendix B Connector and Cable Pin Outs Other Indicators on All LED Bars Power On, No TrafficEthernet Traffic Indicators Ethernet LED Bars Panic IndicatorsMicroRouter 1220i Switch Settings Appendix C LED Patterns and Test Switch SettingsAppendix D Downloading Software From Compatible Systems Page Appendix E Terms Conditions Appendix E Terms and ConditionsAppendix E Terms and Conditions Appendix E Terms and Conditions