Compatible Systems 1220I manual IP Protocol

Page 29

Chapter 6 - Basic Configuration Guide

23

 

 

method and to select a chat script (once you have created one). Use the WAN Chat Scripts Dialog Box (under Global/WAN Chat Scripts) to create your chat script.

TB: Use configure and then set the Dialing, DialOutScript, and DropInact keywords in the Link Config WAN 1 section. Use edit config and create a Chat section to contain your dialing script.

IP Protocol

Required for IP

WAN interfaces which are set for PPP operation do not generally use an IP address. They are set to act as an “unnumbered interface.” In this mode of operation, there are no required settings.

Suggested for IP

These parameters help supply information about the segment that the interface is connected to. With this information, routing can take place.

Set IP RIP 1, IP RIP 2, or OSPF (Open Shortest Path First)

IP Static Routes

CV: Use the TCP/IP Routing: WAN Dialog Box to set RIPor OSPF, and the IP Static Routing Dialog Box (under Global/IP Static Routes) to set static routes.

TB: Use configure and set either the RIPVersion keyword or the OSPFEnabled keyword in the IP WAN 0 (and/or WAN 1) section. Add static routes and a default router using the edit config IP Static command.

Note: If you set RIP to “on” for a dial-on-demand link, you must valso set the update method to triggered to avoid the link being brought up by transmission of RIP information. You should only use triggered operation when you are connecting to another Compatible Systems router at the other end of the link.

IPX Protocol

Required for IPX

WAN interfaces which are set for PPP operation do not generally use an IPX address. They are set to act as an “unnumbered interface.” In this mode of operation, there are no required settings.

Image 29
Contents MicroRouter Installation Guide Page Getting Started Network InstallationIntroduction CompatiView Software Installation Basic Configuration GuideAppendix B Connector and Cable Pin Outs Appendix a Shipping DefaultsSystems Appendix E Terms and Conditions Introduction IntroductionAbout the MicroRouter Getting Started MicroRouter 1220i Installation OverviewCompatiView Software Installation Introduction Network InstallationCommand Line Preparation Basic Configuration GuidePage Getting Started Warranty and ServiceFew Notes Please Read The ManualsWhat You Will Need To Get Started Needed For InstallationSupplied with the MicroRouter Ethernet Connection RequirementsInterface Telco Line Connection RequirementsGetting Started 10Base-T Twisted-Pair Ethernet RS-232 Interface Placing the Router Network InstallationConnecting a Line Device to MicroRouter Connecting the Router to the EthernetConnecting to Twisted-Pair Ethernet Connecting Devices to the V.35 InterfaceConnecting Devices to the RS-232C Interface Connecting an Out-of-Band Management ConsolePowering Up the Router System Requirements Installation and OperationCompatiView for Windows Transport Protocols and CompatiView Out-of-Band Command Line Management Command Line ManagementCommand Line Management Setting Up Telnet OperationCommand Line Management Page Basic Configuration Guide IP Protocol Ethernet Interface ConfigurationRequired for IP Suggested for IPPhysical Communications Settings WAN Interface ConfigurationIPX Protocol Required for IPXRequired for Dedicated/Leased Line Operation Link ConfigurationSuggested for Dedicated/Leased Line Operation Required for Dial-On-Demand OperationIP Protocol Frame Relay Dlci Mappings Frame Relay ConfigurationRequired for IP Unnumbered Interface Required for IP Numbered InterfaceIPX Protocol Smds Addressing Saving a Configuration File to Flash ROMPage WAN Interfaces Appendix a Shipping DefaultsEthernet Interfaces RS-232 WAN 1 Link & Physical Defaults WAN 0 Link & Physical DefaultsPin Outs for V.35 Female Connector DTE Appendix B Connector and Cable Pin OutsAppendix B Connector and Cable Pin Outs Ethernet Traffic Indicators Ethernet LED Bars Power On, No TrafficOther Indicators on All LED Bars Panic IndicatorsAppendix C LED Patterns and Test Switch Settings MicroRouter 1220i Switch SettingsAppendix D Downloading Software From Compatible Systems Page Appendix E Terms and Conditions Appendix E Terms ConditionsAppendix E Terms and Conditions Appendix E Terms and Conditions