Compatible Systems 1220I manual MicroRouter 1220i Switch Settings

Page 40

34Appendix C - LED Patterns and Test Switch Settings

MicroRouter 1220i Switch Settings

0Normal Operation

1Unused*

2Unused*

3Run Boot ROM Downloader

4Unused*

5Erase Flash ROM (OS and Configuration)

6Erase Flash ROM (Configuration Only)

7Unused*

8Unused*

9Allow letmein password for 5 minutes after powerup

Caution: Settings marked with an asterisk may erase your Flash MROM. Please do not use these settings without first contacting Compatible Systems Technical Support.

Image 40

Contents

MicroRouter Installation Guide Page Introduction Network InstallationGetting Started Basic Configuration Guide CompatiView Software InstallationAppendix a Shipping Defaults Appendix B Connector and Cable Pin OutsSystems Appendix E Terms and Conditions About the MicroRouter IntroductionIntroduction MicroRouter 1220i Installation Overview Getting StartedIntroduction Network Installation CompatiView Software InstallationCommand Line Preparation Basic Configuration GuidePage Warranty and Service Getting StartedFew Notes Please Read The ManualsNeeded For Installation What You Will Need To Get StartedSupplied with the MicroRouter Ethernet Connection RequirementsGetting Started 10Base-T Twisted-Pair Ethernet Telco Line Connection RequirementsInterface RS-232 Interface Network Installation Placing the RouterConnecting the Router to the Ethernet Connecting a Line Device to MicroRouterConnecting to Twisted-Pair Ethernet Connecting Devices to the V.35 InterfaceConnecting an Out-of-Band Management Console Connecting Devices to the RS-232C InterfacePowering Up the Router CompatiView for Windows Installation and OperationSystem Requirements Transport Protocols and CompatiView Command Line Management Out-of-Band Command Line ManagementSetting Up Telnet Operation Command Line ManagementCommand Line Management Page Basic Configuration Guide Ethernet Interface Configuration IP ProtocolRequired for IP Suggested for IPWAN Interface Configuration Physical Communications SettingsIPX Protocol Required for IPXLink Configuration Required for Dedicated/Leased Line OperationSuggested for Dedicated/Leased Line Operation Required for Dial-On-Demand OperationIP Protocol Frame Relay Configuration Frame Relay Dlci MappingsRequired for IP Numbered Interface Required for IP Unnumbered InterfaceIPX Protocol Saving a Configuration File to Flash ROM Smds AddressingPage Ethernet Interfaces Appendix a Shipping DefaultsWAN Interfaces WAN 0 Link & Physical Defaults RS-232 WAN 1 Link & Physical DefaultsAppendix B Connector and Cable Pin Outs Pin Outs for V.35 Female Connector DTEAppendix B Connector and Cable Pin Outs Power On, No Traffic Ethernet Traffic Indicators Ethernet LED BarsOther Indicators on All LED Bars Panic IndicatorsMicroRouter 1220i Switch Settings Appendix C LED Patterns and Test Switch SettingsAppendix D Downloading Software From Compatible Systems Page Appendix E Terms Conditions Appendix E Terms and ConditionsAppendix E Terms and Conditions Appendix E Terms and Conditions