Sanyo C3082, C3682 Special Remarks, Setting the Timer, How it works?, Operation Indication

SPECIAL REMARKS

‘‘DRY’’ ( ) Operation

How it works?

•Once the room temperature reaches the level that was set, the unit’s operation frequency is changed automatically.

•During DRY operation, the fan speed automatically runs at lower speed for providing a comfortable breeze.

•‘‘DRY’’ operation is not possible if the indoor temperature is 59 °F or less.

Cooling ( ) operation

•Sometimes the indoor unit may not get to the set fan speed such as LOW under cool operation at very low outdoor temperatures due to the indoor unit being protected from ice or frost.

Power failure during operation

•In the event of power failure, the unit will stop. When the power is resumed, the unit will restart automatically in approximately

5 minutes by the remote control unit.

If the remote control unit is on and left in a location where the unit can receive a signal, then the unit will automatically restart in approximately 5 minutes of power being restored.

Clicking Sound

Clicking sound is heard from the air conditioner

•In cooling operation, any plastic parts may shrink due to a sudden temperature change. In this event, a clicking sound may occur. This is normal, and the sound will soon disappear.

Remote Control Unit

•The remote control unit sends the setting condition to the air conditioner regularly at five minute intervals.

SETTING THE TIMER

NOTE

In the descriptions below, the following settings are used for the temperature and time indicator selector button on the bottom front section of the remote control unit.

•Temperature: °F

•Time: AM, PM

1. How to set the present time

(Example) To set to 10:30 pm.

	Operation	Indication
1.	Press the CLOCK button	The time indication alone
	once if the time indicator is	flashes.
	not flashing.
2.	Press the Advance, Return	The time can be set in 1-minute
	( , ) button until PM 10:30	increments. Holding down the
	is displayed.	button advances the time rapidly
		in 10-minute increments.
3.	Press the CLOCK button	This completes the setting of the
	again.	current time.

12 OI-150-12-EG