Saw Operations
Bevel Cut
•A bevel cut is made at 0° miter and any bevel angle in the range of
•There are two (2) factory set bevel stops at 0° and 47°. (See Adjustment section if adjustments are required.)
•The cast in bevel scale faces the operator for easy reading.
•There is a positive crown molding stop at 33.9°. Disengage this stop unless using. (See cutting Crown Molding for details.)
•The bevel lock handle is spring loaded and can be repositioned by pulling handle out, rotating to desired position and engaging by releasing for use in tight spaces.
•Use sliding base/fence as appropriate. (See Sliding Base/Fence Extension page 54.)
Follow these instructions for making your bevel cut:
1.Move the sliding fence to proper position 1. (See Sliding Fence on page 54.)
2.Loosen the bevel lock handle. Tilt the head assembly to desired bevel angle 2. Tighten the bevel lock handle (Figure 28).
3.Properly position workpiece 3. Make sure work piece is clamped 4 firmly against the table and the fence 5.
!WARNING Use clamping position that does not interfere with operation. Before switching
on, lower head assembly to make sure clamp clears guard and head assembly.
4.Activate the switch. Lower the head assembly and make your cut.
5.Wait until blade comes to a complete stop before returning head assembly to the raised position and/or removing workpiece.
FIG. 28
| 5 |
| 2 |
4 | 3 |
|
1
0°
58