90511 02 CHS6000 Hand SAW 8/16/06 11:11 AM Page 9
stops to ensure a complete discharge of the batteries. Using a screwdriver, remove the screws in the product housing and lift the housing half from the tool. Disconnect the terminal clips from the batteries and lift the batteries out. See “Service Information” for battery replacement.
| TROUBLESHOOTING |
|
Problem | Possible Cause | Possible Solution |
• Unit will not start. | • Battery not charged. | • Check battery charging |
|
| requirements. |
• Battery will not charge. | • Charger not plugged in. | • Plug charger into a |
|
| working outlet. Refer to |
|
| “Important Charging |
|
| Notes” for more details. |
|
| • Check current at |
|
| receptacle by plugging in |
|
| a lamp or other appliance. |
|
| • Check to see if |
|
| receptacle is connected to |
|
| a light switch which turns |
|
| power off when you turn |
|
| out the lights. |
| • Surrounding air temperature | • Move charger and tool |
| too hot or too cold. | to a surrounding |
|
| air temperature of above |
|
| 40 degrees F (4,5°C) or |
|
| below 105 degrees F |
|
| (+40,5°C). |
For assistance with your product, visit our website www.blackanddecker.com for the location of the service center nearest you or call the BLACK & DECKER help line at
ACCESSORIES
Recommended accessories for use with your tool are available from your local dealer or authorized service center. If you need assistance regarding accessories, please call:
WARNING: The use of any accessory not recommended for use with this tool could be hazardous.
SERVICE INFORMATION
All Black & Decker Service Centers are staffed with trained personnel to provide customers with efficient and reliable power tool service. Whether you need technical advice, repair, or genuine factory replacement parts, contact the Black & Decker location nearest you. To find your local service location, refer to the yellow page directory under
FULL TWO-YEAR HOME USE WARRANTY
Black & Decker (U.S.) Inc. warrants this product for two years against any defects in material or workmanship. The defective product will be replaced or repaired at no charge in either of two ways.
The first, which will result in exchanges only, is to return the product to the retailer from whom it was purchased (provided that the store is a participating retailer). Returns should be made within the time period of the retailer’s policy for exchanges (usually 30 to 90 days after the sale). Proof of purchase may be required. Please check with the retailer for their specific return policy regarding returns that are beyond the time set for exchanges.
The second option is to take or send the product (prepaid) to a Black & Decker owned or authorized Service Center for repair or replacement at our option. Proof of purchase may be required. Black & Decker owned and authorized Service Centers are listed under
9