Honeywell WT6500 owner manual Battery Over-current Protection, Shock or Fire Hazard

Page 23

SMARTBOX Installation

16

 

 

 

 

Battery Over-current Protection

The NEC/CEC requires the battery circuit to be protected with a device rated for 125% of the rating of the circuit. The DC-rated fuse or circuit breaker between the battery and the SMARTBOX™ Controller must have a maximum size of 75A (the maximum current rating of the SMARTBOX™ Controller).

SHOCK OR FIRE HAZARD

Over-current protection must be installed to protect the SMARTBOX™ Controller from short circuits and to provide a means of disconnecting it. Failure to follow this warning may result in death, personal injury or property damage.

REVERSE POLARITY DAMAGE

Before making the final DC connection or closing the DC breaker or disconnect, check cable polarity at both the battery and the SMARTBOX™ Controller. Positive (+) must be connected to positive (+). Negative(-) must be connected to negative (-). Failure to follow this warning may result in death, personal injury or property damage.

TURBINE SMARTBOX™ Controller

 

 

(2) #4 THWN-2 + #4 GND

 

 

1” CONDUIT

 

 

MAX DISTANCE 6 FEET.

12V

12V

12V

12V

12V

12V

 

 

OPTIONAL

Figure 2.8 Battery Circuit Diagram

SMARTBOX™ Controller for HONEYWELL™ Wind Turbine WT6500 Owner’s Manual - Rev14

Image 23
Contents Smartbox Controller General Safety Instructions Safety InstructionsSafety Icons Important Safety InstructionsLimitations on USE Battery Safety InformationSafety Instructions Safety Instructions Table of Contents Commisioning For Information On See IntroductionParts Inspection Smartbox ControllerMajor System Components Minimum to be used Battery OverviewBattery Types Not to be usedAmp-hour Ratings Battery SelectionAC Load Detail and Selection Not Recommended Recommended AppliancesIntroduction Smartbox Controller InstallationTurbine Block Diagram System DiagramsRisk of Fire or Explosion Smartbox Controller DiagramMounting EXPLOSION/CORROSION Damage Minimum Clearance for Proper MountingEquipment Damage Shock Hazard and Fire Hazard WiringGrounding Shock HazardTurbine to Wiring DiagramTurbine Current Rating and Wiring Turbine Wiring and DistancesReverse Polarity Damage Turbine Over-current ProtectionBattery Connection Location Battery WiringShock or Fire Hazard Battery Over-current ProtectionAC Output Wiring AC Input WiringAC Output Over-current Protection Turbine Smartbox ControllerJunction BOX Control WiringBattery Setup Chart Battery SetupConnecting the Smartbox Controller Enclosure Internal WiringFire and Shock Hazard Warranty Void WarningTo connect the Smartbox Controller Smartbox Installation For Information on See Commissioning Process CommissioningDisplay Description Set the battery type FloodedCommissioning Process Check all connections for polarityPress Enter to start the turbine Shows if a turbine voltage was foundCommissioning Operation Viewing Operating Status IntroductionTurbine Operating States Starting/Stopping TurbineTurbine Operating States Controller Energy Consumption StatesOver Wind Speed System ProtectionTurbine User Stop State Cool DownFault Description State Required for Fault System FaultsNon Grid-Tie SmartBox Fault Specifications Operations Menu Smartbox Controller Front PanelNavigation Buttons System Menu and NavigationTechnician Menu View Data Menu Battery Setup Menu Operation Specifications Environment Non Grid-Tie Smart Box Electrical SpecificationsInput ChargeWindTronics
Related manuals
Manual 46 pages 4.52 Kb