Honeywell WT6500 owner manual Technician Menu

33 Operation

1.This is the home screen. The SMARTBOX™ Controller will scroll the listed information while in run mode and also the current firmware revision.

2.Turbine Fault Stop. Indicates if a fault has occurred.

3.This is the top menu level. From here you can go to the TECHNICIAN MENU or the START/STOP TURBINE MENU. Pressing enter to make a selection.

4.The Start/Stop Turbine Menu. Pressing UP will place the SMARTBOX™ Controller in user stop mode. In this mode the turbine will not spin and no A/C will be produced. Pressing DOWN will start the turbine. This will start a battery charge cycle.

Technician Menu

	1
	.TECHNICIAN	ENTER/BACK
	..FORCE CHARGE ?
	UP/DWN
	2
	.TECHNICIAN	ENTER/BACK
	..FORCE AC ?
	UP/DWN
	3
UP/DWN	.TECHNICIAN	ENTER/BACK
	..CLEAR PRODUCTION ?
	UP/DWN
	4
	.TECHNICIAN	ENTER/BACK
	..VIEW DATA ?
	UP/DWN
	5
	.TECHNICIAN	ENTER/BACK
	..BATTERY SETUP ?

Figure 4.6 Technician Menu

..FORCE CHARGE

UP=START

..START CHARGE

UP=START

..CLEAR PRODUCTION

UP/HOLD=CLEAR

VIEW DATA

MENU

BATTERY SETUP

MENU

1.Force Charge. This forces the turbine into the bulk charge state to begin charging the batteries.

2.Force AC. This turns on the inverter and switches the transfer switch to turbine AC. It also switches the turbine mode into float charge.

3.Clear production. This clears the Watt-Hour productions values in the turbine both turbine and AC productions values.

4.View Data. Selecting view data moves a menu level down to the view data menu.

5.Battery Setup. Selecting battery setup moves a menu level down to the battery setup menu.

SMARTBOX™ Controller for HONEYWELL™ Wind Turbine WT6500 Owner’s Manual - Rev14