HP 2103R-CSDI manual Cisco Systems Getting Started Guide

2-4 CHAPTER 2: INSTALLING THE EDGE ROUTER MODULE

Quick Installation Follow the general steps outlined in Table 2-1 to install and configure the for Unmanaged Edge Router module in an unmanaged ONline or ONcore hub.

Hubs

Table 2-1 Quick Installation for Unmanaged Hubs

Step	Procedure	Refer to:
1	Unpack the module.	Unpacking Procedures on page 2-6
2	Verify the jumper plug positions on	Verifying Jumper Plug Positions on
	the base and expansion engines.	page 2-7
3	Configure the carrier for operation in	Configuring DIP Switches on page 2-8
	an unmanaged hub using DIP
	switch settings.
4	Insert the module into an open slot	The appropriate installation instructions
	in the hub.	for your hub type in this chapter
5	Attach a management terminal to	Configuring the Edge Router Engine on
	the Edge Router module console	page 3-9
	port.
6	Configure the engine parameters	Cisco Systems Getting Started Guide
	using Cisco Systems setup
	command.
7	Attach WAN cables to the 60-pin	Cable Pinouts on page A-5
	universal WAN connectors on the
	front panel.