HP 2103R-CSDI manual If the NV SEL DIP switch is

Configuring DIP Switches 2-11

If the NV SEL DIP switch is:

■ ON (enabled) – The Edge Router module uses configuration settings stored in its NVRAM. If NVRAM does not contain configuration settings, the Edge Router modules are assigned to the Isolate_1 network.

■ OFF (disabled) – The Edge Router module uses DIP switch settings.

Selecting a Network

In an unmanaged ONcore hub, the DIP switches determine the network setting (unless NVRAM configuration settings are enabled).

1 To select a network:

Set the switches according to Table 2-5.

Table 2-5 ONcore Network Selection DIP Switch Settings

	Switch Settings
Network
Selection	CH SEL 0	CH SEL 1	CH SEL 2	CH SEL 3
Ethernet_1	ON	ON	ON	ON
(default)
Ethernet_2	OFF	ON	ON	ON
Ethernet_3	ON	OFF	ON	ON
Ethernet_4	OFF	OFF	ON	ON
Ethernet_5	ON	ON	OFF	ON
Ethernet_6	OFF	ON	OFF	ON
Ethernet_7	ON	OFF	OFF	ON
Ethernet_8	OFF	OFF	OFF	ON
Isolate_1	ON	ON	ON	OFF
Isolate_2	OFF	ON	ON	OFF
Isolate_3	ON	OFF	ON	OFF
Isolate_4	OFF	OFF	ON	OFF

Switch combinations not listed in Table 2-5 select Isolate_1.

2Disable NVRAM by setting the NV SEL DIP switch to the off position.