ABOUT THIS GUIDE
Introduction | This guide describes how to install and configure a 3Com® ONline™ or |
| ONcore® Edge Router module into the 3Com ONline System Concentrator |
| or ONcore Switching Hub. In addition, this guide provides troubleshooting |
| suggestions in case a problem arises with the module. |
| If the information in the release notes shipped with your product differs from |
| the information in this guide, follow the release note instructions. |
|
|
Audience | This guide is intended for the following people at your site: |
| ■ Network manager or administrator |
| ■ Trained hardware installer or service personnel |
How to Use This Guide
Table 1 shows the location of specific information.
Table 1 How to Use This Guide
If you are looking for: | Turn to: |
|
|
General information about the Edge Router module | Chapter 1 |
Description of the module architecture |
|
Typical applications of the Edge Router module |
|
Features of the Edge Router module |
|
|
|
An overview of the installation and configuration process | Chapter 2 |
Procedures for unpacking the Edge Router module |
|
Procedures for preparing to install the Edge Router module |
|
Procedures for installing the Edge Router module |
|
|
|
An overview of the managed configuration process | Chapter 3 |
Procedures for attaching a management terminal |
|
Procedures for configuring Edge Router carrier parameters |
|
|
|