HP 2103R-CSDI manual Isolating the ONline Edge Router Module, Configuring

Configuring DIP Switches 2-9

Figure 2-2 shows the ONline carrier DIP switch location.

O N 1 2 3 4

Figure 2-2 ONline Carrier DIP Switch Location

Selecting a Network

Use Table 2-4 to select a network by using the DIP switches.

	Table 2-4 ONline Network Selection DIP Switch Settings
		Switch Settings
	Network Selection	Switch 1	Switch 2	Switch 3	Switch 4
	Ethernet_1 (default)	ON	ON	ON	ON
	Ethernet_2	ON	OFF	ON	ON
	Ethernet_3	OFF	ON	ON	ON
	Isolated	OFF	OFF	ON	ON
	Isolating the ONline Edge Router Module
	To isolate the Edge Router module from all backplane networks, set the DIP
	switches to the Isolated position as defined in Table 2-4.
Configuring the	ONcore carrier DIP switches allow you to set the following configuration
ONcore Carrier DIP	parameters:
Switches