HP 2103R-CSDI manual Terminal to Auxiliary port Console Port

Configuring the Edge Router Engine 3-9

To assign a carrier backplane port to a network using network management software, use the following command:

set port slot.port network {ethernet_1 ... ethernet_8}

{isolated_1 ... isolated_4}

For example, the following command sets backplane port 1 (engine 1) in the carrier installed in slot 3 to Ethernet_2:

ONcore> set port 3.1 network ethernet_2

Port 03.01 network id set to ETHERNET_2

Saving the To save configuration changes, use the SAVE command. For example, the Configuration following command saves all configuration changes:

ONcore> save all

If you do not save module settings, you may lose configuration data.

Configuring the Configure the Edge Router engine parameters using a management

Edge Router terminal attached to either the console port or the auxiliary port. Engine

This section includes the following topics:

■Attaching a Terminal to the Console Port

■Using the Terminal to Configure the Edge Router Engine

Attaching a	To attach a management terminal to the Edge Router module console or
Terminal to the	auxiliary port:
Console Port

1Install the mini-DIN to DB-25 adapter cable into the circular connector labeled “console” or “auxiliary” on the Edge Router module. Figure 3-1 shows an example of how to connect the cable to the console port.