HP 2103R-CSDI manual Port Command Ports Syntax for the Show Port command is

4-6 CHAPTER 4: MONITORING EDGE ROUTER MODULE OPERATION

Using the SHOW	The SHOW PORT command displays information about a single port or all
PORT Command	ports.
	The syntax for the SHOW PORT command is:
	SHOW PORT slot.port {verbose}
			{no_verbose}
	The following command displays verbose information for port 1 on an
	Edge Router module installed in slot 1 of an ONcore hub:
	ONcore> show port 1.1 verbose
	Port Display for Module 6102M-SDEK:
	Port	Mode	Status	Network	General Information
	-----	------ -------		-------	----------------
	01.01 LOGICAL		OKAY	ETHERNET_4 2103R-CSDI
	Port Connector:				BACKPLANE
	IP Address:				2.0.0.2
	Subnetwork Mask:				ff.00.00.00
	Station Address:				00-00-0c-c0-3d-63
	Dip Network Setting:				ETHERNET_4

The following command displays verbose information for port 1 on an

Edge Router module installed in slot 4 of an ONline hub:

ONline> show port 4.1 verbose

Port Display for Module 5103R-CSD:
Port Mode	Status	Network		General Information
----- --------	------		--------		----------------
04.01 LOGICAL	OKAY		ETHERNET_1
Port Connector:					BACKPLANE
IP Address:					151.104.15.39
Station Address:
Capabilities:					-NONE-
Native Port Number:					0