HP StoreServ Application Suite for Microsoft Hyper-V Media Add-HyperV, Preconditions, Syntax

B HP 3PAR Recovery Manager for Microsoft Hyper-V Powershell Commands

This section provides additional information about custom Powershell Commandlets for users performing administrative tasks.

Add-HyperV

Add-HyperVadds Hyper-V credentials for users. The command is used with each Microsoft Hyper-V (cluster or standalone host) credentials and managed by the application.

Preconditions

•User must first log on with Login-Rmh.

•Hyper-V name (or synonym) does not already exist.

Syntax

Any optional parameters require square brackets [ ] around them.

Add-HyperV -RmhServerName <RmhServerName> -HypervName <HypervName>

-HypervUsername <HypervUser> -HypervPassword <HypervPassword> [-Verbose]

Table 35 Add-HyperVparameters

Parameter	Optional/Required	Description
-RmhServerName	Required	Host name of the RMH Server. This is
		FQDN or IP address.
-HypervName	Required	Hyper V host or cluster name. This is
		FQDN or IP address. Synonyms are
		checked. The localhost is not supported.
-HypervUsername	Required	Hyper-V username. If cluster, ensure all
		controller nodes in the cluster have the
		same username. If not specified, a
		dialog box will be presented to enter
		credentials.
-HypervPassword	Required	Hyper-V password. If cluster, ensure all
		controller nodes in the cluster have the
		same password. If not specified, a
		dialog box will be presented to enter
		credentials.
-Verbose	Optional	Displays progress messages.

Success Paths

•Scenario 1: Add Hyper-V is successful.

Add Hyper-V successful for specified Hyper-V host.

Failure Paths

•Scenario 1: Session owner is invalid.

Every session command received on RMH Server is validated to originate from the same IP address that initiated the session. If IP does not match, the command fails.

•Scenario 2: Cannot communicate with host.

RMH Server cannot communicate with a specified Hyper-V host.

62 HP 3PAR Recovery Manager for Microsoft Hyper-V Powershell Commands