Control panel messages (continued)
Control panel message | Description | |
REPLACE SUPPLIES | At least one supply item is out and | |
alternates with | needs to be replaced and another supply | |
item is either out or low. | ||
| ||
For status press |
|
Recommended action
1.Press 
to identify which supplies should be replaced.
2.Press 
for help.
or
See Replacing supplies and parts for more information.
See Supplies and accessories for more information.
REPLACE SUPPLIES
alternates with
To continue press 
REPLACE TRANSFER KIT
alternates with
To continue press 
REPLACE TRANSFER KIT For help press 
Request accepted please wait
More than one supply item is low, and the SUPPLIES LOW setting in SYSTEM SETUP is set to STOP.
The transfer unit is near end of life and the SUPPLIES LOW setting in SYSTEM SETUP is set to STOP.
The transfer unit is at end of life.
The printer has accepted a request to print an internal page, but the current job must finish printing before the internal page will print.
1.Press 
to identify which supplies should be ordered.
2.Order the identified supplies.
3.Press 
to continue printing.
See Supplies and accessories for more information.
1.Order the transfer kit.
2.Press 
to continue printing.
See Supplies and accessories for more information.
Press 
for help.
or
See Replacing the transfer kit for more information.
See Supplies and accessories for more information.
No action necessary.
Resend upgrade
Resetting Kit Count
The firmware upgrade was not completed successfully.
YES was selected in the RESET SUPPLIES menu to reset the counts for any of the supplies that cannot be detected as new.
Attempt upgrade again. You might need to use the parallel port to send the upgrade file.
No action necessary.
Restoring | The printer is restoring factory settings. | No action necessary. |
factory settings |
|
|
Restoring... | The printer is restoring settings. | No action necessary. |
150 Chapter 8 Problemsolving | ENWW |