Control panel messages (continued)
Control panel message
RAM DISK FILE
SYSTEM IS FULL
alternates with
Ready
To clear press
RAM DISK IS WRITE PROTECTED
alternates with
Ready
To clear press
Description
For the HP Color LaserJet 3700 series printer only.
The printer received a PJL file system command that attempted to store something on the file system but was unsuccessful because the file system is full.
For the HP Color LaserJet 3700 series printer only.
The file system is protected and no new files can be written to it.
Recommended action
1.Use HP Web Jetadmin software to delete files from the RAM disk memory and try again.
2.To remove this message from the display, press .
See HP Web Jetadmin for more information.
1.To enable writing to the RAM disk memory, turn off write protection using HP Web Jetadmin.
2.To remove this message from the display, press .
See HP Web Jetadmin for more information.
RAM DISK X
Initializing
alternates with
DO NOT POWER OFF
Ready
The new RAM disk installed in slot X is initializing.
The printer is online and ready for data. No status or device attendance messages are pending at the display.
For the HP Color LaserJet 3700 series printer only.
No action necessary.
No action necessary.
Ready Diagnostics mode
alternates with
To exit press
Cancel Job key
Receiving upgrade
RELOAD TRAY X TRNSPRNCY <SIZE>
alternates with
Verify transparency
meets specification
The printer is online and ready for data. No status or device attendance messages are pending at the display.
A firmware upgrade is in progress.
The transparency currently loaded might not be supported.
No action necessary.
Do not turn the printer off until the printer returns to Ready.
CAUTION
Use only transparencies specified for use with HP Color LaserJetprinters. Non- compatible transparencies can damage the printer. See the HP LaserJet Printer Family Print Media Specification Guide.
1.Remove all
2.Load compatible transparencies in Tray 1.
See Printing on special media for more information.
148 Chapter 8 Problemsolving | ENWW |