Network configuration
NOTE
NOTE
The network configuration feature is available for the HP Color LaserJet 3700 series printer when an EIO device is installed.
You might need to configure certain network parameters on the printer. You can configure these parameters from the printer control panel, the embedded Web server, or for most networks, from the HP Web Jetadmin software or the HP toolbox.
For more information about using the embedded Web server, see Using the embedded Web server (HP Color LaserJet 3700 series printer only).
For a complete list of supported networks and for instructions on configuring network parameters from software, see the HP Jetdirect Print Server Administrator’s Guide. The guide comes with printers in which an HP Jetdirect print server is installed.
This section contains the following instructions for configuring network parameters from the printer control panel:
●configuring TCP/IP parameters
●disabling unused network protocols
Configuring TCP/IP parameters
You can use the printer control panel to configure the following TCP/IP parameters:
●usage of the BOOTP file for configuration parameters (the default is to use the BOOTP file)
●IP address (4 bytes)
●subnet mask (4 bytes)
●default gateway (4 bytes)
●idle TCP/IP connection timeout (in seconds)
52 Chapter 3 I/O configuration | ENWW |